Industry Directory | Manufacturer
KrellTech manufactures advanced polishing systems and equipment for processing photonic components for a variety of markets ranging from telecom/datacom to industrial, and bio-medical to avionics. www.krelltech.com
Industry Directory | Manufacturer
KrellTech manufactures advanced polishing systems and equipment for processing photonic components for a variety of markets ranging from telecom/datacom to industrial, and bio-medical to avionics. www.krelltech.com
New Equipment | Test Equipment
Anritsu S820C Microwave Site Master, 3.3 GHz to 20 GHz, Built in DTF The Anritsu S820C spectrum analyzer is a wide band, very sensitive receiver. It works on the principle of "super-heterodyne receiver" to convert higher frequencies (normally rangi
New Equipment | Test Equipment
PNA-L Series Microwave Network Analyzer, 300 kHz to 6/13.5/20 GHz and 10 MHz to 20/40/50 GHz Features: 108 dB of dynamic range and TRL/LRM calibration, on-wafer, in-fixture, and waveguide measurements Option 120 = 300 kHz to 1
Used SMT Equipment | In-Circuit Testers
Agilent X281C-013 The Agilent X281C transforms X-band (8.2 GHz to 12.4 GHz) waveguide transmission line into 50-ohm coaxial line. Features: Waveguide Designator: EIA WR-90 MIL-W-85/1-077 Flange Designator: UG-135/U MIL-F-3922/54C-008 Optiona
Used SMT Equipment | General Purpose Test & Measurement
Features: * Handheld, battery-operated design * Lightweight at only 4.2 lbs. (including battery) * Superior Immunity to RF interference * Locate long range problems with 517 data points * Tune Mode for waveguide component alignment/testing * Mu
Industry News | 2013-03-29 07:29:36.0
IPC – Association Connecting Electronics Industries® has opened registration for the IPC/FED Conference on Embedded Components, a forum for designers, manufacturers, suppliers and end-users of embedded component technologies to discuss the latest technological advancements.
Industry News | 2012-09-10 12:48:23.0
To help companies gain the most out of HDI technology, Raytheon is sponsoring the “IPC HDI Conference: Advancements in Materials, Processes and Applications,” October 24–25 in Los Angeles, Calif.
Technical Library | 2010-10-28 01:27:38.0
Optical waveguides based on organic materials have been fabricated in a laboratory environment but the scaling and manufacturing processes needed to produce these waveguides have been scant. The volume production of low loss organic waveguides in a conven
Technical Library | 2017-04-06 16:50:56.0
Silicon photonics is an IC technology where data is transferred using light that is routed on the chip using optical waveguides (Figure 1). Silicon photonics is best known as a method to solve problems with high input/output bandwidth applications. For example, because of ever-growing bandwidth requirements in datacenters, the optical transmit and receive heads are being placed closer and closer to the board and the IC. But, designers also apply this technology to biosensors, medical diagnostics, and environmental monitoring. Regardless of the application, photonic ICs always need integration to electronic circuits and this results in unique challenges.
In the world of makers, people enjoy the fun of designing and developing hardware/ software, even final electronic products. They will not concentrate a lot on the cost and manufacturability. But it is quite different from lab to factory, when it com
Organic Optical Waveguide Fabrication in a Manufacturing Environment Organic Optical Waveguide Fabrication in a Manufacturing Environment Optical waveguides based on organic materials have been fabricated in a laboratory environment
