Electronics Forum | Sat Jun 13 07:22:13 EDT 1998 | Toni Casas i Pujadas
We are very concerned about outgassing in wavesoldering. If anyone knows how to use properly well pcb's before soldering in order to avoid this problem please let me know. I have this problem in FR4 large double sided pcb's. My soldering line is SOLT
Electronics Forum | Mon Dec 31 03:51:14 EST 2001 | hany_khoga
Dear all: We had a severe curvature in our boards after wave soldering.Could a second pass in the wavesolder m/c reduce this curvature. If not then what do you recommend to solve this problem. Also how it can be avoided. Best Regards Hany
Electronics Forum | Thu Jan 03 07:49:20 EST 2002 | hany_khoga
Thanks Scott: The Assembley is Mixid ( reflow then wavesoldered). It is One curcuit. Is the Tg averagely known for FR4 PCB assemblies? Hany
Electronics Forum | Wed Jan 21 10:13:14 EST 2004 | ADAM
What is the most effecient form of heating ,ie calrod, IR, convection , or a mixture ? to produce a good thermal profile on a wavesoldering system on thermally challenging multi-layered boards? Thanks Adam
Electronics Forum | Thu Jul 03 09:44:59 EDT 2008 | amcross
Thx, L, but we are looking for a permanent staff member here at our facility to optimize first our wavesolder, then other areas of our processes. Things are running well as they are today; we are simply looking to improve.
Electronics Forum | Thu Jul 10 15:17:51 EDT 2008 | amcross
Understood, BT. We're looking for both -- the analytical mind and educational training of the degreed engineer AND the experience in wavesolder. If it was an easy match to find, I wouldn't be bothering you great guys!!! :)
Electronics Forum | Wed Jan 14 06:41:08 EST 2009 | andrzej
I did not tried this before (never hada chance to do it) but I considered such option - maybe try using temporary wavesolder mask on such small components. Run both sides of PCB through SMT oven and then mask 0402 completely and go with wavesoldering
Electronics Forum | Mon Jul 14 16:38:56 EDT 2014 | sumote
If anyone knows any tech-service that I can contact to assist me with this wave-solder machine, please let me know!
Electronics Forum | Fri Dec 15 11:23:23 EST 2000 | John
I searched the archives and couldn't find anything specific. Our designers would like me to wave solder an SO18 on an upcoming product. My IPC standards have land patterns, but no recommendation on wavesoldering. This is a higher pin count than we
Electronics Forum | Wed Nov 11 23:45:53 EST 1998 | Mark D.
What are the factors that go into determining PCB Board temperature requirements for the Wavesolder process? Most of the recipes I've seen call for preheating the PCB to around 230F - 250F. This temp is about 210F - 230F below the typical solder temp
