Electronics Forum | Wed Aug 10 11:57:16 EDT 2005 | pr
Is the peelable mask (put on by the boardhouse) flat on the surface of the pcb? If so can you tell me the material name, so maybe I can find a picture? We have to print adhesive on the board, so the mask has to be flat. That is why Kapton from the b
Electronics Forum | Tue Aug 09 13:25:24 EDT 2005 | pr
From what I can gather, the annular rings are used for grounding when these boards are put in housings. A screw goes through the hole and is torqued down. If there is excess solder on the annular ring, the screw doesn't seat properly. The pallets cov
Electronics Forum | Wed Aug 17 22:41:37 EDT 2005 | davef
Peter are you having fun with solder masks erwat? We saw this years ago with LPI solder masks. It shows occasionally with other masks. We agree with Russ. If nothing [eg, alcohol, flux thinner, acetonitrile, or water] dissolves the haze, then it
Electronics Forum | Sat Jan 23 16:07:20 EST 1999 | Steve Gregory
| hi, | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier proces
Electronics Forum | Wed Jan 27 20:34:13 EST 1999 | parag palshikar
| | hi, | | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier pr
Electronics Forum | Sat Nov 08 09:42:22 EST 2003 | ethercom
Hi: I have seen this problem before. It is caused by improper curing of solder mask by the fab manufacturer. When you run the board thru' wave solder, and then wash the board, you see the problem of white residue. However, when you apply heat, you c
Electronics Forum | Wed Mar 16 16:02:55 EST 2005 | Dreamsniper
Hi, Need your help. Easy one. How do you evaluate Spot-on Mask, those that are peelable and used for wave soldering and conformal coating? thanks and regards,
Electronics Forum | Thu Mar 17 09:22:55 EST 2005 | davef
J-STD-001, Appendix C, Material and Process Compatibility Testing
Electronics Forum | Thu Feb 12 12:30:16 EST 2015 | stevezeva
I remembered something from the TechNet a long time ago about heating the board with a heat gun to see if the white spots disappear. I searched the archives and found this from Bill Kenyon: Quick identification of solder mask white spots- if it is t
Electronics Forum | Mon Jan 26 11:41:04 EST 2004 | pbarton
Some questions: Is the peelable/spot masking only being applied to the earthing points on the one side or to both sides? Is the peelable mask you are using specifically designed for coating masking or is it the same as that you use for masking sold
.jpg)