Electronics Forum | Fri Mar 02 15:32:52 EST 2001 | jagman
We are seeing a white, powdery residue following the Wave process. Is this a solder masking issue (poor cure from the PCB mfg) or Wave process related? Any input is greatly appreciated.
Electronics Forum | Fri Sep 18 09:25:16 EDT 2009 | ysutariya
There's not really a good answer except that I think that the industry wasn't really prepared for such an increased use of white soldermask combined with the importance of using the white as a reflecting surface. Essentially, the resins commonly u
Electronics Forum | Fri Apr 26 12:18:24 EDT 2002 | Yngwie
Today the line experienced the white gloves turns green at the point of contact when holding fresh board that came out from wave soldering. Was that the effect of inproper solder mask curing at PCB house during fabrications ? For a proper cured solde
Electronics Forum | Thu Oct 11 17:15:31 EDT 2012 | boriskilk
We have seen two issues which have caused problems with solder mask adhesion. The first was improper curing of the mask but also solder temps which were too high, particularly with a white tin finish. Rather than tell your supplier their material i
Electronics Forum | Thu Jan 20 13:56:51 EST 2022 | stivais
For me it seems that the board is already assembled & soldered. Before assembling the board had been (poorly) washed (misprint perhaps) and the spots are just melted solder paste. Aren't those solder balls in the grooves between the pads and solder
Electronics Forum | Tue May 26 15:53:39 EDT 1998 | Chrys
| We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localized to
Electronics Forum | Tue May 26 16:35:53 EDT 1998 | Ryan Jennens
| | We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localized
Electronics Forum | Mon May 14 13:33:36 EDT 2007 | jax
Solderability!!! The CM in question has probably seen too many solder problems with White Tin in the past. We have had the same issues. To save us from spending too much time and money(verifying pure Tin plating thickness, Chemical leaching from th
Electronics Forum | Fri Mar 19 05:21:11 EST 1999 | Vinesh Gandhi
Hi Folks, Need help, on white spots/marks which we are getting after wave soldering. This problem has started only once we have shifted to the no clean flux. Prior, to this we have been using aqueous cleanable flux without problems. If brushed vi
Electronics Forum | Thu Mar 19 20:12:32 EDT 2020 | slthomas
Stephen, you are spot on with your description. Here's a .jpg with paste layer, copper, and solder mask.