Electronics Forum | Wed May 18 07:22:06 EDT 2005 | davef
Wire bonds don't stick when bonded * Check pull and shear strength. * Depending on point of failure, review parameters. * Listen during bonding, if there is a high pitch buzz, there is vibration in the system somewhere, "seek and destroy". * Get the
Electronics Forum | Tue Mar 16 20:45:51 EDT 2010 | r_nelson777
check out DIAS in HongKong. They may have what you need. website. http://www.diasautomation.com email. sales@diasautomation.com
Electronics Forum | Tue Jan 30 17:58:49 EST 2007 | flipit
Hi, I would not be too concerned about what the shape of your wirebonding fiducial is. Cross, Square, Diamond, Circle, will all work well for you. I use a "+" and a diamond. Your machine magnification will be great, so don't make the fiducials to
Electronics Forum | Thu Nov 03 02:34:46 EST 2005 | Rosewood
We've recently encountered some problems with wire bond strengths. I'm looking for anybody that has had some experience with different types of substrate contamination and methods for cleaning. There is no visible contamination on the gold pads, bu
Electronics Forum | Wed Jan 31 17:30:54 EST 2007 | GS
Thanks a lot flipit, I am not directly involved in this "problem" but is my friend that have his CM rejecting PCBs because it says the "+" mark (spokes lengths) are out of tolerances. It seams CM bonder's require tolerance +/- 0,05(? not sure). I d
Electronics Forum | Thu Sep 19 02:45:33 EDT 2002 | bugsjoe
Thank you ur reply Dave. Let me explain our COB workflow: 1. unpack PCB (FR4,LPI,HASL)(the thickness of gold and nickel we can't be find)(No SMT before) 2. clean the pcb by rubber 3. blow the pcb by di-ionic gun 4. attach die by adhesive gel 5. cure
Electronics Forum | Tue Jan 09 22:04:48 EST 2007 | Guest
Set Up Guy, I am not sure if the COB you are refering to means Circuit on Board . If yes, this process also include SMT . Package is a combination of some passive components and bare die. Passives are normally attached thru SMT using solder te
Electronics Forum | Wed May 16 10:37:34 EDT 2001 | davef
Similar to my response to your previous posting on this topic dated 5/8/01, things to try are: 1 Contact your non-supplier [Streckfuss] using the contact points at http://www.streckfuss.com/wave_soldering.htm, obtain source drawings for components o
Electronics Forum | Tue Apr 17 09:38:04 EDT 2001 | CAL
With some help from our good Friends at Agilent Technologies our RF Lab includes testing up to 100GHz. Equipment includes Vector network analyzer, signal analyzer, dual channel power meter, noise filter meter, advanced impedance analyzer (including
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
.png)
