Career Center | , | 2013-03-07 10:18:07.0
Currently work as Equipment Engineer at Integrated Microelectronics Inc., Philippines handles Line Maintenance Technicians, that performs production equipment setup and sustenance. Implements/creates improvements on assigned area. Maintains group KRA
Electronics Forum | Mon Sep 11 14:15:28 EDT 2000 | Gary
I am looking for some details about the failure modes in popcorned components. Does the component usually fail to operate. Is the damage likely to extend to the gold bond, wires, or substrate. We have experienced a high failure rate on a subset of
Electronics Forum | Thu Oct 29 13:06:58 EST 1998 | smd
| Scott, | | Just wondering whether you are all set with the mats and whether you got help via your Forum posting. Would appreciate it if you could share the results here. | | Thanks, | | Cunli | | | I need new mats that would be suitable for
Electronics Forum | Mon Sep 21 20:45:55 EDT 2009 | davef
10.4. Pre-Cure Examination. Immediately after material application, the uncured conformal coating shall be examined for: a. Bubbles and Air Entrapments. These defects shall be broken by vacuum, with a sharp probe, or other appropriate tools. b. Bridg
Electronics Forum | Wed Sep 18 18:40:05 EDT 2002 | dougt
Here is how smema works: Machine A has a board to give to machine B. Machine A has an opto or a relay that will turn on or close when it is ready to pass this board to machine B. This is the "board available from previous" signal, telling machine B
Electronics Forum | Sat Mar 06 08:19:50 EST 1999 | Dave F
| Clarissa, | | Dave had good suggestions. We load several boards manual at this time. We set our components up in clearly marked bins. The documentation includes a chart with the part number, bin number, reference designator and color code for t
Electronics Forum | Tue Feb 02 09:47:45 EST 1999 | Justin Medernach
| Hi everybody. | Somebody know any consideration or special care to make a profile for BGA's. | | any advice is aprecied. | | thanks | Al Carrillo | | Hi Al, A BGA should be looked at just like any other surface mount device. However, just
Electronics Forum | Tue Feb 02 17:51:45 EST 1999 | gcollier
| | Hi everybody. | | Somebody know any consideration or special care to make a profile for BGA's. | | | | any advice is aprecied. | | | | thanks | | Al Carrillo | | | | | Hi Al, | A BGA should be looked at just like any other surface mount d
Electronics Forum | Fri Jan 22 18:54:54 EST 1999 | Steve Gregory
> If you are inheriting a system, you probably don't have a lot of choice, >>but with a little ingenuity, you can pull a Steve Gregory: Grab some duct >>tape, a book of matches, and a videotaped rerun of MacGyver for >>inspiration. HEY! Whaddya mea
Electronics Forum | Thu Sep 19 21:23:42 EDT 2002 | davef
I'm not saying that an eraser will necessarily work. What I'm saying is that some erasers may cause more trouble than the eliminate. Look here http://aic.stanford.edu/jaic/articles/jaic28-02-003_2.html We prefer a brand called Ruby Red. The "ole
.gif)
