Electronics Forum | Fri Feb 18 22:32:27 EST 2005 | pd not cruel
I�m surprised how un professional the so-called experts can be. After all we all had our start sometime and if you can never remember asking a un qualified question in your entire career then you probably have a bad memory. This is an open forum for
Electronics Forum | Wed Feb 23 14:17:21 EST 2005 | scombs
We also have 4796's and 4791's and have had the same issues with 0402 parts.. All the suggestions listed in the last post will help quite a bit. We found our biggest problem was the board supports due to the operators using the wrong type of pins ,
Electronics Forum | Thu Nov 14 18:06:05 EST 2019 | tey422
It doesn't really matter which PnP machine you use. The correct way to cut down the variety is to use the same mfg p/n part for the whole time. Some would try to cheap by increasing the part size tolerance, but that's not the right way to do it. To
Electronics Forum | Wed May 24 15:45:38 EDT 2000 | JAX
John, Would you enlighten us to what machines you are talking about. I have never heard of such things. Typically, machines map out the boards with the locations of the fiducials relative to there CAD locations in order to account for stretch. Local
Electronics Forum | Fri Jan 27 16:58:24 EST 2006 | solderman
Hi Ams, I often cringe when I read replys like the ones you got. I will give 'chris' the benefit of the doubt in that he is sincere in his response. However, there are people posting here with agendas to sell specific equipment. Without knowing
Electronics Forum | Wed Nov 28 06:56:57 EST 2007 | shy
the paste is necessary for the component that had no glue. btw, for solder paste specs, 150C is at reflow time plus soaking time and i believe it will cause nothing to the glue and can cured as per recommended? correct me if i'm wrong.
Electronics Forum | Mon Jan 06 11:39:46 EST 2003 | davef
We always hate ourselves when we do this, because it always ends-up laying our guts on the table for someone to stomp on, but we just can�t help ourselves. We do not obtain the same results from both Jon's and Ashok's approaches. Maybe our math in
Electronics Forum | Tue Feb 27 11:03:09 EST 2007 | Marcin
Hi All, Anybody knows what is the minimum clearance between through hole component and chip component? Problem description: On bottom side of my pcb are only 0603 chip components mounted on glue. One of the component is located very close to hole
Electronics Forum | Tue Dec 04 10:30:16 EST 2007 | slthomas
Q: The question I have is do they wet in wave solder, and if they do, why does it matter what happens to them in reflow? A: Yes, but somebody here don't agree with me that the glued part need help from wave to get the good wetting. They are wrong
Electronics Forum | Sat Mar 24 12:31:31 EDT 2007 | diesel_1t
Hi there. Ok, i have a little big question for fuji Erudites: when machine run out of parts on any device it tells to machine "parts out (and part number)" So, a signal from anywhere (maybe a PLC output) will tell to the machine "hey i'm out of parts
winsouce.jpg)
