Technical Library | 2017-03-30 18:34:52.0
There are multiple methods, each with its associated benefits for given applications, for printing either solder paste or paste flux for BGA rework. Each of these methods is best-suited for a given situation, board layout and skill level of operators performing the BGA rework. This discussion will layout the various methods and present the specific circumstances for which the specific technique is most wellsuited. In addition, the pluses and minuses for each of the approaches will be discussed in detail.
Events Calendar | Tue Mar 07 08:00:00 EST 2017 - Tue Mar 07 14:00:00 EST 2017 | Rolling Meadows, Illinois USA
Rework Symposium
Technical Library | 2007-02-01 09:36:26.0
Purpose: Compare the Surface Insulation Resistance of reworked BGA Test samples made with standard solder balls using a flux only reattachment and samples made including the StencilQuik™ product from Best Inc. with solder balls using a flux only reattachment.
New Equipment | Solder Paste Stencils
These fixture plates facilitate the controlled dipping of flux or paste onto the balls under the BGA packages. Flux or paste is controlled at a depth of 50-60% per cent of the ball diameter prior to placement of a BGA or to place a PoP component on t
New Equipment | Solder Paste Stencils
Eliminate hours of solder mask damage repair time for bga sites while improving rework yield. Are you frustrated by the time it takes to repair mask damage underneath the BGA during the rework process? Are you squeezed for space on the PCB in an
Technical Library | 2007-01-31 15:17:04.0
The goal of this project is to evaluate the reliability of lead-free BGA solder joints with a variety of different pad sizes using several different BGA rework methods. These methods included BGAs reworked with both flux only and solder paste attachment techniques and with or without the use of the BEST stay in place StencilQuick™. The daisy chained test boards were placed into a thermal test chamber and cycled between -25ºC to 125ºC over a 30 minute cycle with a 30 minute dwell on each end of the cycle. Each BGA on the board was wired and the continuity assessed during the 1000 cycles the test samples were in the chamber.
New Equipment | Solder Paste Stencils
These fixture plates facilitate the controlled dipping of flux or paste onto the balls under the BGA packages. Flux or paste is controlled at a depth of 50-60% per cent of the ball diameter prior to placement of a BGA or to place a PoP component on t
New Equipment | Rework & Repair Equipment
The BEST EZReball™ process is the answer to your reballing problems. This BGA reballing process simplifies the process while eliminating the clean up of all those paper remnants, allowing for better yields and faster reballing times. The simplicity o
Demonstration of BGA rework via stencil printing. BEST's StikNPeel stencil is an adhesive backed stencil which allows users to stick the stencil in to place and simply peel it off the PCB with a temporary adhesive system. This leaves consistent print
EZReball demonstration video. Simple and Fast new reball method! The new BEST EZReball™ process is an answer to your reballing problems. This unique method simplifies the reballing process allowing for better yields and faster reballing times. http: