Electronics Forum | Mon Nov 25 02:15:07 EST 2019 | mk15
it is possible to test x belt motor and x wagon motor.
Electronics Forum | Fri Oct 28 13:27:58 EDT 2011 | kmakiya
Check to see if the mount precision is set to high in the package acceleration field. We set this to normal and the oscillation went away. I wonder if slowing down the x-axis would help.
Electronics Forum | Mon Oct 31 02:36:01 EDT 2011 | kenmar
Thanks , If you reduce the placement precision the X-Axis does not make any noise but than I had placement /pickup problems when it comes to Ic's.Slowing down did not make any difference.
Electronics Forum | Tue Sep 09 17:09:44 EDT 2014 | chemers
Thank you to all. The problem was dust in the x wagon motor. We cleaned the motor out and everything works again. Rebecca
Electronics Forum | Wed Jun 15 19:46:15 EDT 2022 | mikevb
Hey All. I figured it out. It turns out that the problem was simply a loose coupler on the x wagon motor transducer. I had only checked one screw in the past but the other screw was apparently loose as well.
Electronics Forum | Tue Jul 17 12:57:41 EDT 2007 | cyber_wolf
Is your machine a TP9 2U ? If you have a UFP or a MY series machine this condition usually points towards a bad X-wagon motor.
Electronics Forum | Thu Jan 06 13:56:46 EST 2011 | ev
Thanks for this detail. The X wagon responds as per the instructions here so I'll give the cables a good inspection.
Electronics Forum | Sat Oct 29 14:33:34 EDT 2011 | tech1
Try swapping out the motor controller boards and see if the problem moves. More than likely it is the motor, coupling or the encoder. Some of the suggestions about reducing the acceleration in the package is a good idea but this will not provide a lo
Electronics Forum | Mon Oct 31 02:38:18 EDT 2011 | kenmar
Hi Phil, Thanks I will contact Mydata to see about a possible software upgrade.
Electronics Forum | Mon Oct 31 02:41:34 EDT 2011 | kenmar
Yes removing the accuracy stops the problem but than we have pickup/placement problems especially on I.cs I cannot switch over the cards since there is only one 3A card in the machine and I think it is unique. Thanks
.gif)
winsouce.jpg)