Electronics Forum | Tue Sep 22 16:39:10 EDT 2009 | rmitchell
Hi, We are getting a E-Hydra-1 Frame grabbing failed on caps and resistors and also a Light Curtain trigger X wagon. I spoke with mydata and they indicated the light curtain might be getting set off and causing the frame grabbing failure. I cleane
Electronics Forum | Fri Aug 06 14:01:53 EDT 2021 | tomdegas
Unfortunately all my tools are spring loaded. Yes I do know the tool install utility. I have been running and maintaining the 3 MyData machines for over 20 years and I never saw an error like this. I grease our tools once a month so I know that is
Electronics Forum | Fri Mar 24 16:45:03 EDT 2023 | tey422
I believe I was working with the early MY12 model too. Yes, the X-wagon blue ribbon cable were showing wear and tear very fast. Another frequent break downs were the center-jaw, ribbon broke. Most of the Mydata repairs can be done inhouse with spar
Electronics Forum | Tue Oct 27 11:20:16 EDT 2009 | smtspecialist
I had the same problem back in March with my MY12, since I have two identical lines i swapped things around until swapping the x-wagon motor (the one for fine movements). When I swapped the x-motor I move the problem from one line to the other gener
Electronics Forum | Fri Sep 05 09:33:32 EDT 2014 | cflames17
It could very well be the Safety Relay located inside the ELMO PSU (Bottom left in computer cabinet). I just had the same problems on 2 MY9's within 2 months apart. the Part cost around $700.00 from Mydata (Now Mycronic). These fail commonly with old
Electronics Forum | Thu Apr 16 13:23:41 EDT 2009 | bk
well by the looks of it you have pretty much replaced just about everything that could cause the problem. The only one i haven't seen is the cable going from the computer box up to the x-wagon boards. Just out of curiosity when you took your motor fr
Electronics Forum | Tue Apr 21 12:48:13 EDT 2009 | bk
ok you verified that the motor was bad. So now i would go back and verify that your voltages are still good on the back of the computer box and on the booster board. If they all check out fine. I would take the mot x board from your working machine a
Electronics Forum | Thu Jul 20 10:48:43 EDT 2006 | pms
Ev, This error could be caused by any number of problems. Is there an error message in the message window before hardware initiation error? If so, what is it? A failure in any axis (x,y,z,c,theta,y-wagon,tray-wagon) could cause your symptom. Paul
Electronics Forum | Wed Jan 05 10:55:12 EST 2005 | OverTheHill
WOW Sr.Tech, 40K worth of bent tools? I'm about ready to be sh*t canned because of 1K's worth. As for trimming the mags, the product is running fine (many boards) and then out of nowhere the tool bends, so I assume my PERFECT operators trimmed the ma
Electronics Forum | Tue Apr 05 11:03:13 EDT 2005 | cyber_wolf
There are several things that can cause these errors. It sounds as if you have 2 problems. A (Z) problem and a theta problem. 1. Check that the Z-locks are functioning properly in the service program. Make sure that when they are un-locked they don'
