Electronics Forum | Tue Aug 18 13:43:52 EDT 2009 | victorp
Is there a standard (such as IPC) or common industry practice in regards with x-out marking on rejected boards of a panel? Do board shops have to X-out both sides of the rejected board, or one side? If the answer is one side, which side should be ma
Electronics Forum | Thu Apr 18 18:34:33 EDT 2024 | ahernand75
Hello SMTnet, I would like to know from you guys your experiences of how the use of X-Out boards impact your units per hour on your lines. There are different scenarios where some of you might have only one lane reflow oven and others may have 2 lane
Electronics Forum | Tue Apr 27 13:59:13 EDT 1999 | RG
Have there been any studies done on the actual cost of running X-Out's. Please provide any inputs you might have. RG
Electronics Forum | Thu May 08 17:26:06 EDT 2008 | rogercox
Are there recommended image reject marks in order to process x-outs from a PCB supplier? Do they have to be in the copper or will silkscreen suffice?
Electronics Forum | Mon Mar 18 13:39:43 EDT 2013 | vpham
Please help, how do you skip x-out boards on a panel using Juki 2050 pnp machine?
Electronics Forum | Fri Dec 27 07:20:38 EST 2019 | dipak123
We have Mirtec MV-6 OMNI machine. If programer changes in part number ,then that part x-out from it's place.Value of X & Y incresed 10X compare to other parts in ATT.
Electronics Forum | Wed Sep 01 02:48:49 EDT 2021 | cmchoue
Hi Experts, I'm looking for how to auto skip the AXI(X-Ray) inspection on X-out board,Did any folks have the experience on this? Looking for your advice. AXI machine,Virtox and Matrix Thank you CM
Electronics Forum | Tue Apr 23 09:22:02 EDT 2024 | wippsen
of course it has an impact on line capacity. x-out boards have a shorter cycle time, but you have to push more panels through the line to reach the order quantity
Electronics Forum | Wed Mar 15 04:32:14 EST 2006 | rlackey
Hi Brad, I don't know if this helps, but we had a policy of not accepting x-outs on rigids, and of max 10% per panel on Flexy boards (as long as the local fiducial was blacked out for the bad board) I'm always suspicious of x-outs as it points to pr
Electronics Forum | Thu Feb 16 02:44:03 EST 2012 | fadzril
Dear all, Have anyone deal with X-Out boards? These defects are declared if one cavity or more from multi cavity boards are defective. There have been a request to use these boards in order to reduce the multi cavity board spoilage at supplier. Ho
