Electronics Forum | Mon Apr 18 18:23:41 EDT 2022 | youngbuck
Hello everyone, We have a Siemens HS50 error going on as soon as we boot up. It shows message saying "Machine is in test mode." Cause: Initalizing gantry axes. Start Sitest and check machine (firmwre versions,configuration, etc. It will try to refere
Electronics Forum | Tue Nov 13 04:47:19 EST 2018 | dhammika
hi Siplace Hs-60 defected due to below error Error- • Machine error:2271 Can bus: reception call aborted with time out seg:0 DEV: head 2 #:1 (this is not only head 2 ,error raise with all head interm
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Tue Oct 20 08:58:27 EDT 2009 | soudomphong
m/c error 3564 raceway monitoring triggered-gantry 3. In the help menu it says topic does not existed. Anybody has any idea what this error code mean? This is siemens hs60.
Electronics Forum | Thu Jul 03 11:29:27 EDT 2014 | bobpan
oh....by reseat the cards....i mean the transport cards that are located in the top right side of the machine above gantry 2.
Electronics Forum | Tue Sep 20 13:37:00 EDT 2005 | jasont
We have x30 PPU's across x3 FCM Base 1's which are not working properly (error is "image too low"??). Please advise on how to repair/replace these (besides Assembleon themselves). Thanks in advance, Jason
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Fri Mar 29 16:57:07 EDT 2013 | aemery
Gentlemen, Just became a member and scanning the old posts hoping to help people out with their MPM printers. Most of this info is correct, the last post was the best. Offsets on an Accuflex printer can be put in either per process program or glob
Electronics Forum | Wed Nov 06 12:58:56 EST 2013 | bobpan
The key to figuring out mirae machine failures 'most of the time' is found in mr-terminal. Is this message from mr-terminal or is this the windows/program software error. Mirae 1010 machines have boot failure problems often. Sometimes if the z positi