New Equipment | Assembly Services
The board is designed by customer and it's for Network interface controller. We did one-Stop EMS Service for this project (PCB manufacture, components sourcing, SMT and THT assembly): Product name: 8 Layer HDI PCBA board Material: FR-4 TG180, Shengy
New Equipment | Assembly Services
The board is designed by customer and it's for Set-Top Box PCBA board. We did one-Stop EMS Service for this project (PCB manufacture, components sourcing, SMT and THT assembly): Product name: 4 Layer PCBA board Material: FR-4 TG180, Shengyi Thicknss
New Equipment | Assembly Services
The board is designed by customer and it's for TV Box PCBA board. We did One-Stop EMS Service for this project (PCB manufacture, components sourcing, SMT and THT assembly). Product name: 4 Layer PCBA board Material: FR-4 TG170 Thicknss: 1.6mm Surfac
Industry News | 2019-05-16 01:27:23.0
There are several surface treatment for PCB board: bare board (no treatment on the surface), rosin board, OSP (Organic Solderability Preservatives), HASL (lead tin, lead-free tin), plating gold, immersion gold, etc., these are relatively conscious treatment. Many people can't tell the difference between plating gold and immersion gold, thinking that it is the same thing, it is a big mistake. The following is a brief introduction to the difference between plating gold and immersion gold.
Electronics Forum | Fri May 11 15:43:41 EDT 2001 | davef
More information would be helpful. For instance: * Talk about the distribution of the problem, including a single lot or from various lots and over components and component types on the board * Tell us about the board (ie, thickness, type, solder ma
Electronics Forum | Fri Apr 16 12:47:48 EDT 2010 | boardhouse
White solder mask does have a tendency to yellow within the lead free environment. so double coating will not help any. I due believe the flux is a factor in the yellowing but due to the color is the main reason. Find out what brand of S/M mask they
Electronics Forum | Fri Mar 19 11:01:42 EST 1999 | Dave F
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Thu Jan 10 02:16:09 EST 2019 | ameenullakhan
Hi Steve, Thanks. This from the trusted supplier. HASL finished PCB. Even PCB supplier is using the water wash flux for fabrication. Its almost eliminated with N2 environment. And we had got a expert view from Dr. Lee of Indium on the issue st
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411