 XMP(4SE 4ST)E9607729000.jpg)
Parts & Supplies | Pick and Place/Feeders
> FUJINTAI TECHNOLOGY CO.,LTD JUKI E32707290A0 EJECTOR UNIT www.fujintai.com JUKI E32717290A0 EJECTOR UNIT IC FUJINTAI TECHNOLOGY CO.,LTD JUKI E3271760000 SOLENOID VALVE www.fujintai.com JUKI E3272729000 SOLENOID VALVE FUJINTAI TECHNOLOGY CO.
Electronics Forum | Wed Apr 23 15:23:16 EDT 2008 | cassedra
I am looking for users of YesTECH AOI that would be interested in comparing notes on what minor problems you have had and how you may have figured out what you could do that didn't require YesTECH support? Or little tricks that help you make the mac
Electronics Forum | Fri Oct 05 09:03:36 EDT 2018 | dontfeedphils
Yea, probably need a new board, which may be tricky considering how old these models are getting now. I had a B2 at my last shop and we upgraded to a Koh Young Zenith 3D. At the time, Yestech told us the camera in the B2 would go for around 10k jus
Electronics Forum | Fri Jan 19 08:03:07 EST 2018 | babe7362000
Is anyone Familiar with Yestech B2 Calibration. I can not get the Camera angle to pass. Please message me if you can help me. Thanks
Electronics Forum | Fri Jan 25 10:15:56 EST 2019 | babe7362000
Does anyone know what Led is used on the Yestech B2 light boards. I need to replace them and can not find a board, so I need to replace the LEDS. Or is it something else causing the leds to not go any brighter?
Electronics Forum | Thu Oct 04 14:38:00 EDT 2018 | babe7362000
Thanks I will try to calibrate again.
Electronics Forum | Thu Jan 25 07:48:37 EST 2018 | cgreiner
Send me your email and I will send you a calibration procedure that I used to adjust my B2 unit. Best Regards
Electronics Forum | Wed Sep 26 11:14:09 EDT 2018 | babe7362000
Can anyone tell me how to adjust the B2 Brightness? Sometimes it is hard to see the markings, because it is too dark. It has been awhile since I have done this. Thanks for any information.
Electronics Forum | Wed Nov 07 14:24:50 EST 2018 | babe7362000
Is there a calibration file that saves on the Yestech after a Calibration is complete? and If so where is that located? Thanks
Electronics Forum | Fri Jul 19 14:54:41 EDT 2013 | dontfeedphils
I suppose I worded that poorly, we run a B2 bench-top unit later on in the process (QA area to be exact) so it isn't in line with anything and doesn't have to keep up with anything feeding it upstream. And we run Juki equipment.
