Electronics Forum | Mon Jul 13 05:54:39 EDT 2009 | rway
Hello all, We are looking to purchase another AOI system with side angle cameras. Currently we are using a YesTech M1 system that has only a top-down camera (it can't be upgraded with side cameras). Does anyone have experience with YesTech F1 sys
Electronics Forum | Mon Jun 20 03:37:43 EDT 2005 | MMunos
We have 3 inline Yestech systems in our facility. One system being used pre reflow for paste inspection and the other two for parts and solder. The systems work great for paste inspection (Better than what the sales guy told us). They are also very g
Electronics Forum | Fri Oct 31 12:50:12 EDT 2008 | devgru
Dominik, I have to agree with Andrew on his choice of Inspection Technology, but not the vendor. I looked at 2 of the 3 that you are asking about (TRI did not make my cut as I just didn't get a good feeling from them). I also looked at the Mirtec and
Electronics Forum | Fri Jul 19 10:01:30 EDT 2013 | dontfeedphils
In a past life I ran F1 systems post placement / pre reflow behind a MyData My12E, so it didn't exactly have to keep up with a speedy chip shooter, but it did pretty well. The AOI would end up being the bottle neck some of the time, but not because
Electronics Forum | Fri Sep 05 19:56:56 EDT 2008 | hegemon
We did extensive side by side (by side) testing of three AOI machines Omron, YesTech and Mirtec. In the end, even with weighted scores, the difference in the top two machine was still only four/tenths of a point. Third place was a distant 14 points
Electronics Forum | Thu Jun 02 08:27:08 EDT 2005 | klukens
I agree with Steven. I have been involved with AOI for over 18 years. I was first introduced to it when I worked for Solectron. The AOI machines back then were more or less used as a selling item and very cumbersome to use. I have used and or operate
Electronics Forum | Sat Oct 02 15:26:59 EDT 2010 | rway
Possible, but difficult. What algorithm programs are you referring to? Mirtec and YesTech both utilize algorithms in their respective software. The algorithm is simply a series of instructions to perform the inspection. In this case, rules-based,
Electronics Forum | Tue Aug 26 16:24:18 EDT 2008 | rway
We currently use a YesTech M1 system and we are looking to buy another. Two important areas to look at when pursuing AOI equipment: 1) Camera resolution 2) Light sources Depending on your needs, camera resolution can be important depending on the si
Electronics Forum | Thu Sep 07 07:38:14 EDT 2006 | travis1977
I have experience programming and using the yestech system in a high volume high mix environment. The system seemed to work well until I used a more sophisticated system. When I changed jobs and had another opportunity to spec. in paste and post-r
Electronics Forum | Fri Oct 29 11:59:35 EDT 2010 | rway
We currently have two YTV-M1 inline-systems from YesTech. I have been using them for around 3 years now. They are descent machines. If you decide to go with YesTech, go for the F1 system. This will give you the ability to upgrade with side camera
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400