Electronics Forum | Thu Jul 18 05:05:34 EDT 2013 | bobpan
Make sure that the lens is clean and you dont have any parts down inside on the camera. Also sometimes the leds that shine up to the part are bent in crazy directions. Make sure they look like they are all aimed up at the same direction. Is the brigh
Electronics Forum | Mon Sep 30 16:36:00 EDT 2013 | richardconnell
I have a Universal Instruments Corporation TAB Bonder. Oldish machine. Initial fault on machine : - "Axis Head 1 Z DAC Limit error during move absolute command" Other fault seen after we reset power, Zeroed axis etc. - Axis Head 1 - Z error not re
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Thu Apr 04 05:33:19 EST 2002 | ianchan
Hi, hope this helps : 1) BCC (bump chip carrier) production for us, was with a 5mils Stencil. The outer perimeter smallish pads are not much of a problems. For the central large pad, we split the paste print (corresponds to the Stencil apperture op
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
