Industry News | 2011-03-02 17:28:40.0
Essemtec announces that it will feature a range of new equipment in Booth #773 at the upcoming IPC APEX EXPO, scheduled to take place April 12-14, 2011 at the Mandalay Bay Resort & Convention Center in Las Vegas.
Industry News | 2012-10-29 13:09:31.0
, PP-Elektronix has become one of the leading electronics manufacturers in Poland. Maintaining a continuous high quality level has made its name known throughout Europe, America and Asia.
Electronics Forum | Wed Sep 15 10:55:21 EDT 1999 | Scott S. Snider
| Hi, | | Can someone pls suggest to me the best reflow temperature setting | for a force air convection oven. The details is as follow. | 1) Heller 1700s | 2) 12 zone---6 top and 6 bot | 3) Solder paste --- Qualitek 691 non clean | 4) board size :
Electronics Forum | Wed Sep 15 12:07:50 EDT 1999 | Earl Moon
| | Hi, | | | | Can someone pls suggest to me the best reflow temperature setting | | for a force air convection oven. The details is as follow. | | 1) Heller 1700s | | 2) 12 zone---6 top and 6 bot | | 3) Solder paste --- Qualitek 691 non clean | |
Electronics Forum | Thu Sep 16 12:06:29 EDT 1999 | Scott S. Snider
| | | Hi, | | | | | | Can someone pls suggest to me the best reflow temperature setting | | | for a force air convection oven. The details is as follow. | | | 1) Heller 1700s | | | 2) 12 zone---6 top and 6 bot | | | 3) Solder paste --- Qualitek 691
Electronics Forum | Thu Sep 04 02:43:09 EDT 2008 | benefon
Thanks This error only occurred with one oven profile with the reflow zone temperature set at 270�C. Perhaps it really has to do with the exhaust pull as the oven is operating very near its temperature limit with this profile. I will check that. Tha
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Wed Dec 17 03:26:17 EST 2003 | Kev
Hi Lads, Thanks for all of the replies. To answer a few of your questions..... My wave is a Hollis PT500N. It has 3 zones of pre-heater rod elements. Each individual element (601195-01) is 500 watts. There are 16 elements per zone so 8 Kw per zone.
Electronics Forum | Tue Dec 16 06:42:51 EST 2003 | Kev
I am having problems achieving correct pre-heater temperatures with our Hollis solder wave. Our original "Verification Golden board" program uses a conveyor speed of 5ft per minute and pre-heat temps of 300, 350, 400 respectively. Our "golden Board"
