Electronics Forum | Tue Jan 03 15:16:53 EST 2006 | Cmiller
In circuit testing is expensive up front because of the fixture cost but the tests are fast. AOI programs can be develpoed in less than a day but take longer to run. If you have good test coverage, in circuit would be a better choice in my opinion-if
Electronics Forum | Fri Mar 24 15:31:08 EDT 2017 | elrohir
I have a supplier that want to upgrade all nails on a huge amount of ICT fixture due to test RoHS compliant PCBAs. My thought is that even if there are a very small fraction of residues left on the pins it will never go over the 1000PPM level. In fu
Electronics Forum | Fri Oct 30 06:48:19 EDT 2009 | leadthree
Is there any official or in-official in-house standard for ICT pin maintenance on volume boards? Like, how many test can or should one pin do? Currently we just change when we get contact problems. That probably after 5000 tests or so. But I guess
Electronics Forum | Fri May 13 02:43:21 EDT 2016 | karts22
Hi, We have several fixtures for GenRad 228x tester and would like to change sensor plates as they are quite worn. The problem is that 3 fixtures have different plate sizes for the same IC, side length is 10-12mm. What would be the best size for sens
Electronics Forum | Fri Oct 13 15:55:53 EDT 2000 | Dave F
Guys, two things: 1 Fluxes have different probing chaacteristics. Consider broadening your horizons. 2 Look at SMTnet thread ... ICT Fixtures No-Clean Flux - Cartman 14:04:14 03/16/2000
Electronics Forum | Thu Nov 14 09:02:46 EST 2002 | MA/NY DDave
Hi Making contact has been one reported problem, so some testers put in higher force probes that then might cause problems. If fixturing is done correctly, the OSP is done correctly, and test follows close in time after soldering little problems s
Electronics Forum | Fri Aug 22 00:25:20 EDT 2003 | mantis
Kenny, Out of curisoty why do you need to paste the vias.Is it due to contact reliability at test.Can these vias not be soldered during wave process (if any).Can the Style of probe used in the ICT test fixture not be changed to accomodate these unsol
Electronics Forum | Wed Nov 29 09:25:42 EST 2006 | russ
So why are you telling us about the solder bar? What is the flux? that is what you need to change, you have a rosin based flux it sounds like. you can change probes in test fixtures or change flux chemistries. Russ
Electronics Forum | Thu Aug 04 09:32:03 EDT 2011 | rway
No need to clean unless the sticky residue is an issue for you. If you are working with RF, it could be an issue. You may have probe contact problems as well with ICT and FT fixtures. We use a low residue flux for our wave solder machines (Kester
Electronics Forum | Wed Aug 22 13:16:23 EDT 2012 | rway
Most likely the depaneling is not your issue, but I do concur that there is some mechanical stress occurring somewhere. What about any fixturing for FT/ICT?
I.C.T is a manufacturer from China that offers SMT, DIP, PCBA conformal coating equipment and turnkey solution.
I.C.T Industrial Park, Building 1
Dongguan, 30 China
Phone: +86 13670124230