Pin mixers or pin agglomerators effectively convert very fine powders into workable, easy-to-handle micro-pellets. The FEECO Pin Agglomerator (pin mixer) is comprised of a cylindrical stationary casing which houses an axial rotor extending the full
The VMEbus is designed for 19-inch rack technology and supports bus lengths up to 21 slots. In this system, slot 1 is on the left of the rack, with the rest of the bus extending to the right.
Used for Coaxial measurements. The probes are 50 ohm impedance and the ground shield extends to test pad. Patented Design
.jpg){kind=logo}
The pinnacle qualification for PCB designers, IPC Advanced Designer Certification extends the Designer Certification programme to new heights.
Extend the life of industrial robots with custom cable assemblies from TRI. assembly. For more information please visit our website
Specifications : Six Color, Sheet-Fed Offset Press with Coater and Extended Delivery. Sr.#:153, 71 Mill. impressions, Semi-APC (Semi Automatic Plate Change), Semi-Automatic Plate Hanger, Full PQC Console, with Remote Ink, remote Water and remote Regi
Vertical Access press will house any of our form and trim tooling for processing SMD's The lower die set extends out from the press after processing for easy acces to the device ater processing. This system is available in either a manual or semi-au
The Feeco paddle mixer (pug mill) is a horizontal mixing, conditioning and agglomerating device. Its design is based on a horizontal U-type trough with dual shafts and paddles extending the length of the trough. The action of the pitched paddles move
SCANFLEX® is a revolutionary new hardware platform, created to enable for extended Boundary Scan test and ISP solutions, taking full advantage of the technical potential provided by today’s and tomorrow’s standards. SCANFLEX excels when it comes to s
New Equipment | Solder Materials
Common Flux Thinner is a solvent that is used to thin Water Soluble, No Clean and RMA fluxes in foaming and some spray applications. Use of Common Flux Thinner is suggested when the flux acid number is too high due to solvent evaporation or residues
winsouce.jpg)
.png)
