New Equipment | Test Equipment
The PogoPlus® Series address the unique demands of loaded board testing, featuring an enhanced version of the legendary bias-ball design to virtually eliminate "false opens". ECT offers a full range of sizes and tip styles to accommodate all manners
Everett Charles Technologies (acquired by LTX-Credence, which was acquired by Cohu)
Overview • Almost 10. times faster than standard 80C51 at the same frequency • Ultimate low gate count • Power Management Unit The DT8051 is area optimized, tiny soft core, of a single-chip 8-bit embedded microcontroller, based on World's f
Overview • higher performance than standard 68000 • delivered with fully automated test-bench • complete set of tests The D68000 soft core is binary-compatible with the industry standard 68000 32-bit microcoprocessor. It has a 16-bit data b
Overview The DSPIS is a fully configurable SPI ma slave device, designated to operate with passive devices like memories, LCD drivers etc. The DSPIS allows user to configure polarity and phase of serial clock signal SCK. A serial clock line (SCK) s
New Equipment | Test Equipment
The Agilent Medalist i1000 in-circuit test (ICT) system is a low-cost in-circuit test solution which now comes with digital testing capabilities while maintaining its original low-cost fixture solution. The Medalist i1000 in-circuit test (ICT) syst
New Equipment | Rework & Repair Equipment
Since 1982, Metcal has been a recognized worldwide leader in the electronics assembly marketplace. As part of OK International, Metcal’s industry-leading position addressing advanced technology in conduction soldering and rework/repair, has and will
Overview The DUSB2 is hardware implementation of full/high-speed peripheral controller that interfaces to UTMI bus transceiver. The DUSB2 contains the USB PID and address recognition logic, state machines to handle USB packets and transactions, end
Overview The DMAC is hardware implementation of media access control protocol defined by the IEEE standard. DMAC in cooperation with external PHY device enables network functionality in design. It is capable of transmitting and receiving Ethernet f
Overview • Almost 60 times faster than the original 80C51 • Almost 5 times faster than 80C251 - at the same frequency • Quad-Pipelined architecture DQ80251 is a revolutionary Quad-Pipelined ultra high performance, speed optimized soft cor
Overview I2C is a two-wire, bi-directional serial bus that provides a simple and efficient method of data transmission over a short distance between many devices. The DI2CM core provides an interface between a microprocessor / microcontroller and a