New Equipment | Solder Paste Stencils
MPM UP2000 HiE Screen Printer Substrate treatment Minimum/maximum size 2"x 2"(50.0 mm x50.0 mm) to 20" x 16" (508 mm x 406 mm)(16 "or larger substrate requires special clamps
New Equipment | Board Handling - Storage
Low Cost PCB Transport Racks for up to 50 Printed Circuit Cards of up to 18" (460 mm) deep are made of antistatic material. Side plates can be adjusted from 5.9" (150mm) to 13" (330 mm).Use in TKD Inserter. Specifications: Size: 15.7"D X 18"W X 2
New Equipment | Board Handling - Storage
Flat PCB holding trays are designed to hold up to 25 PCBs for storage and transport at manual workstations. These trays will hold virtually any PCB size. As with all transport racks, these are made of antistatic material. Specifications: Size: 17
New Equipment | Board Handling - Storage
These holding trays are designed to handle more flexible PCBs. Support on two sides prevents printed circuit cards from flexing or moving during transport. Available in two sizes to hold 25 or 30 PCBs. Specifications: Size: 11.4 X 10.2 X 5.1" 290
New Equipment | Board Handling - Storage
This F9100 PCB Transport Cart is made with the same side panels as the F9054. Built into an extruded aluminum frame, the rack provides for up to 100 large panles to be stored straight down, sideways or horizontally depending on your application.The f
The FKN Systek S100 is an economical PCB singulating saw for moderate production volumes and laboratory use. The diamond saw blade with the linear bearing positioning table to guide the PCB to be cut, allows for quick and clean singulation of PCB
New Equipment | Board Handling - Storage
Double Faceplug Stackable PCB Transport Racks for up to 50 Printed Circuit Cards of up to 12.9" (330 mm) are made of antistatic material. Side plates can be adjusted from 3.2" (80mm) to 9.8" (250 mm). Available with PCB stop rods which can be mounted
New Equipment | Board Handling - Storage
Side by side stackable PCB transport racks for up to 100 printed circuit cards of up to 7.4" (190 mm) deep are made of antistatic material. Side plates can be adjusted from .7" (20mm) to 9.8" (250 mm). Specifications: Size: 21.6"W X 7.5"D X 17.99
The FKN Systek S200 is a semiautomatic diamond blade depaneling saw which will cut a populated PCB panel one line at a time. The operator places the panel onto the input tray and positions the cutting line over the blade travel path. Pushing the sta
Cut panels without scoreline and with overhanging components. The S300 diamond blade depaneling saw is ideal for use in singulating assembled PCBs. Singulate panels up to 12" wide. Microprocessor controlled STI safety interlock Long Lasting Di