ProntoTEST-FIXTURE used by electronics manufacturers will accurately setup your Automatic Test Equipment (ATE), Flying Probe and design your "bed of nails" test fixturing. In minutes Unisoft ProntoTEST-FIXTURE software translates CAD and Bill of Ma
New Equipment | Education/Training
Component Rework/Board Repair Training This is a 5-day, advanced course for anyone responsible for quality and reliability of reworked or repaired electronic assemblies. It is a comprehensive hands-on training program with 80% lab work. The certific
Nordson ASYMTEK’s Fids-on-the-Fly™ option is up to 5.5X faster than the traditional stop-and-capture mode for locating fiducials. Reducing time spent performing this essential, non-dispense routine can increase UPH as much as 35 percent. Fiducials a
New Equipment | Solder Paste Stencils
These fixture plates facilitate the controlled dipping of flux or paste onto the balls under the BGA packages. Flux or paste is controlled at a depth of 50-60% per cent of the ball diameter prior to placement of a BGA or to place a PoP component on t
New Equipment | Solder Paste Stencils
These fixture plates facilitate the controlled dipping of flux or paste onto the balls under the BGA packages. Flux or paste is controlled at a depth of 50-60% per cent of the ball diameter prior to placement of a BGA or to place a PoP component on t
New Equipment | Rework & Repair Equipment
BEST HotDots™ are designed to simply and cleanly attach jumper wires on a board. HotDots™ are built to survive at high temperature as both the adhesive and the polyimide material are designed to withstand wash and reflow temperatures. HotDots™ are a
Used to slit material prior to use in a carrier fabrication system.
ACS will not submit a candidate's profile to any clients without prior authorization.
New Equipment | Tape and Reel Equipment
We offer equipment to place components in tape from tube, optional inspection of the device prior or after placement into tape
Hand held pneumatic solder paste dispenser for depositing solder paste on a stencil prior to printing. Eliminates the use of messy paste jars and spatulas. Uses standard 700 gram cartridges. Ideal for use with a semi-automatic or manual stencil pr
winsouce.jpg)