Universal Gang Programmer Ultra-Fast High Speed NAND Flash Gang Programmer Support NAND FLASH, NOR FLASH, Serial EEPRO/FLASH and more Ultra-high programming speed. Programs four devices in parallel. PC hosted, network and stand-alone(no PC req
New Equipment | Component Programming
The JTAGMaster Tester and Programmer is a fully integrated solution for the configuration and diagnosis of Programmable Logic Devices (PLDs). This unit includes : * A boundary-scan tester to arbitrarily observe individual pins and therefore determine
Ideal for wood stove stack monitoring. Low-cost and easy to use! 0 to 1023 Degrees Celsius Programmable high and low limit alarms RS-232 Output Dry Contact Alarm Relay Output 4000 Temperature Memory Programmable Sample Rate Fahrenheit or Cels
New Equipment | Test Equipment
The Multi Clock Divider Board (MCD) Clock provides a one board solution, capable of accepting a wide frequency bandwidth, for the testing of signal generating devices such as crystals and oscillators. Why use: The low-cost MCD replaces the need f
Single and Multi Target ISP Programmer In-System (ISP) Programmer High programming speed selectable: Adapt to cable length and load feature for target board. Supports online (USB2.0 high-speed) and offline mode simultaneously. Supports all comm
New Equipment | Rework & Repair Equipment
The PCT-1000 is a programmable preheater that provides users the ability to increase heat capacity with highly controlled thermal output. The PCT-1000 can be used in a variety of processes including soldering, desoldering, SMD rework operations and,
New Equipment | Test Equipment
The SI5010 programmable scanner provides the capability of switching and routing up to 16 high-frequency input and/or output signals. It always maintains a clean 50 ohm environment through the use of 50 ohm coaxial reed relays. Software configurabl
The DX-350 Series offers 10 user programmable dispense routines and 4 operating modes. The time, pressure and vacuum read-outs are displayed digitally. It is intuitive to use and allows accurate reproduction of sequences of beads or dots. The DX-350
New Equipment | Component Programming
Description : With ProgMaster Universal Programmer embedded in DP3000-G2, and supports different input/output peripherals, like tube, tape, and tray, provides an overall solution for IC programming. DP3000-G2 supports all kinds of IC families, such
The serial Input and Output channels are highly programmable and fully independent. The standard interface offers Data, Clock and Strobe. The programmable output rates and a user oscillator position allow for flexible frequency selection. RS422/485 a