Simplify Dispensing with GPD Global’s Island Series Dispense Platforms Island Series robots give you versatility to do simple, repetitive automation jobs. Work areas range from 300 mm x 400 mm to 400 mm x 400 mm. All Island Series robots are compati
ProntoVIEW-MARKUP is assembly CAD Viewer & Gerber Viewer software used by electronics manufacturers to quickly find components, pin, shorts between traces, etc. ProntoVIEW-MARKUP is also a redline tool that allows annotation of the assembly to creat
The FKN Systek K4000 motorized linear blade depanelizer is designed for high volume singulation of scored and skip scored Printed Circuit Boards. No programming necessary. (Switch select operating mode and speed) Singulate panels with components
The FKN Systek S100 is an economical PCB singulating saw for moderate production volumes and laboratory use. The diamond saw blade with the linear bearing positioning table to guide the PCB to be cut, allows for quick and clean singulation of PCB
FKN Systek K3000 - Singulate scored and skip scored panels up to 24" long ESD protective mat on back table Adjustable front and back support table Singulate panels with components up to 2.5" high Available in 18" blade (standard) or 24" blade (
Low Cost Punch For Singulation Small Tab Routed Panels N200 singulates one tab at a time with upper and lower pinch blades. Singulate curve routed and odd shaped boards. Top and bottom knife set cuts tabs cleanly. Minimal stress on PCB. Toolin
New Equipment | Selective Soldering
ECOSEL - 300 is a table top compact offline selective soldering machine. Solder pot and flux sprayer are fixed, the PCB is articulated with a X/Y stepper motor, Z with an air cylinder, inline N2 heating system, and the nozzle travel path can be progr
New Equipment | Selective Soldering
Designed to replace other fluxing systems in selective fluxing applications, Sono-Tek’s ultrasonic selective fluxing system offers the highest degree of accuracy and fine line control. Controlled velocity spray will give maximum top side fill and low
New Equipment | Rework & Repair Equipment
Desktop Reflow Oven For Reballing and Prebumping of SMD Components The new MiniOven-04 is perfectly suitable for a wide range of applications, from small QFNs to very large BGAs. This is due to our extensive selection of stencils and masks for almos
New Equipment | Test Equipment
The CSM Instruments Table Top Instrument places the performance of the standard Nanoindentation Tester (NHT) into a small and simple-to-use instrument which is ideally suited to routine nanoindentation testing where a full platform configuration may
