Electronics Forum | Fri Feb 01 12:23:46 EST 2008 | mulder0990
If you do not want to buy a new feeder there should only be 2-3 parts you need to change on your CP-4 feeder to make it an 0802. the only difference between the 0804 and the 0802 are the Link, the sprocket, and the stopper. Everything else is exact
Electronics Forum | Fri Dec 15 05:02:42 EST 2000 | SaiWong
It is not gonna work. Even though you fine tuned the CP3. 0603 is the maximum. The camera design is only for the 0603 maximum. If you use it for 0402. I think at least 60% of the component are gone. Also, there is no 0802 feeder for the CP3. How can
Electronics Forum | Mon Feb 14 02:50:29 EST 2005 | K S
Dear Sir, We are having Fuji CP VI and 0804 feeders. Now in new boards we want to load comp. of package 0402 in the available feeders. Can any one tell us is it possible to convert 0804 type of feeders into 0802 by changing the gear which control pit
Electronics Forum | Fri Dec 15 12:26:30 EST 2000 | SaiWong
If it has the 54 mm camera, it works. But it just too slow & not efficiency. To increase your porductivity, you need a CP6 or 642 with 0802 feeders.
Electronics Forum | Fri Feb 22 13:24:24 EST 2008 | mulder0990
How did I know senior was going to get in here too. Nice to see you again. I figured as much with the height difference, but I do not have the equipment here to test my thoughts. We somehow have our machine dialed in to run the 0201 parts with W
Electronics Forum | Sun Jul 08 23:05:57 EDT 2001 | Darby
John, Tenryu/Amistar/i-Pulse made stainless replicas of feeder tape for various pitches and feeder widths. Part # for 0402 is "MT-0802" ( 8mm wide x 2mm pitch ). Standard 8mm wide tape is " MT-0804". If you can't get any of these, spend an hour on yo
Electronics Forum | Fri Feb 22 10:46:04 EST 2008 | mulder0990
Yes, we have. We do have one machine that can place the 0201 parts. I have bought some 0.4mm tape leaf covers and replaced the 0.7mm covers on some CP6 0802 feeders. I calibrate the feeders as tight as I can and make sure the feeders that we use a
Electronics Forum | Tue Jul 22 08:26:03 EDT 2008 | mmjm_1099
I would suggest calling Fuji and they can do a webex with you. But, if you wish to figure it out yourself here you go. 1.) Go into the program you wish to change. 2.) CP43 machine configuration 3.) Pick which holder you wish to change and a drop dow
| 1 |
