Electronics Forum | Fri Aug 24 13:21:59 EDT 2018 | babe7362000
What do others use as far as solder paste type, stencil thickness and aperature size for a .4mm Ball Pitch CSP. Ball diameter is .3mm. Please let me know your thoughts or what you use. Thanks
Electronics Forum | Thu Aug 30 13:06:10 EDT 2018 | emeto
I don't know your board, but for this specific part: 10mil round aperture on a 3.5mil stencil with type 4 paste wold be ideal
Electronics Forum | Wed Aug 29 03:16:20 EDT 2018 | cannizzaro
It is recommended that the thickness of the stencil of 0.1mm, the steel mesh should be partially nano-coated. It is best not to dry easily, and the particles are not easy to be too large. I have tried ALLPCB for this kind of BGA in the past and they
Electronics Forum | Mon Feb 14 13:25:52 EST 2005 | gregp
EIA-481 standard allows the maximum pitch on tape to be 4mm less than the tape width (12mm width and larger). So it is within the standard allowances. As for how common 20mm pitch on 24mm tape is I can not say. I am surprised a 24mm tape feeder ca
Electronics Forum | Mon Feb 14 14:46:42 EST 2005 | russ
We use Samsung and our 24mm feeders have 8,12,16,and 20mm pitch settings. I have found 20mm pitch quite common. My favorite is yhe 12 on 12 our feeders don't support that, we have to put them up on 16mm feeders our cycle them 3 times on a 4mm pitch
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Sun Jun 14 19:41:35 EDT 2020 | yakout
hello michal have a nice day i need to adjust the pitch from 4mm to 8mm
Electronics Forum | Tue Mar 02 10:19:41 EST 2004 | loz
Hi all, we have recently seen a design that consists off a QFP100, pitch at 25". Also in the centre of this footprint is a FBGA165 footprint, pad size .4mm @ 1mm pitch. We have been informed that we will fit the QFP. I want to remove the BGA pads fr
Electronics Forum | Thu Jun 16 08:31:15 EDT 2005 | jh0n!
The most part I have the most difficulty with is a 16mil QFN. We found that reducing stencil thickness to 4mil, and reducing aperatures for the IC by 20%, and setting local fiducials to the IC helped immensely. We used to get 75% or more bridged ou
Electronics Forum | Mon Mar 04 22:50:03 EST 2002 | Nell
Hi, Could anyone tell me where can I get the 0.4mm pitch CSP Dummy Component and the Test PCB? Any comments will be appreaciated. Thanks and Regards. Nell
