Electronics Forum | Mon Aug 03 04:51:58 EDT 2009 | lococost
From alpha metals lead free alloy impurities bulletin: "Levels greater than 0.025% may start to slow the wetting speed and could affect the hole fill performance. If process performance is OK then levels up to 0.05% are OK."
Electronics Forum | Wed Aug 26 04:31:20 EDT 2009 | prasadz
In XP142E very often we are exprencing the R Axis Servo error. When we reduce the Speed to 0.5 it becomes OK. Any body can give solution for this.
Electronics Forum | Fri Nov 06 22:13:57 EST 2009 | isd_jwendell
I use laser centering with 0.5mm lead pitch, with good results.
Electronics Forum | Wed Apr 07 03:44:40 EDT 2010 | jackevest
The missing rate spec. of normal machine is under 0.3%, for our experience 0.1% is normal for average, if you can maintain the machine well, like the nozzle cleaning, feeder maitain...you can keep the 0.05%.
Electronics Forum | Thu Jul 22 07:30:21 EDT 2010 | nitronica1
does anyone know where I can get replacement conveyor/drive belts for a Fuji/astro pcb 0.5m conveyor? pref from the UK or europe the length of the belts are approx 630mm and 6mm wide, flat with bumps on bottom side
Electronics Forum | Sun Dec 11 22:49:23 EST 2011 | darby
7mm FOV with graduations of 0.05mm. They'll cost around $100 - $150. Fun for measuring other "stuff" as well. Enjoy yourself amigo and you're right, printin' is REAL important.
Electronics Forum | Sun Jan 17 22:16:04 EST 2016 | cmarasigan
We are using KIC (kicthermal.com) in reflow profiling. It uses thermocouple wires about 0.5 meter only each point. Previously, Winkic the machine built in software which requires about 5 meters wire. No need for the operator to stand there and feed t
Electronics Forum | Mon Feb 29 23:41:09 EST 2016 | padawanlinuxero
Is more a guess but, your drawing is missing things, more precise the legends on the edge of the drawing, but for what I can see the diameter of the ball is 0.30 +- 0.05 hope it helps!
Electronics Forum | Tue Dec 20 04:35:09 EST 2016 | pcbepcb
I designed 0.5mm through hole, and 1.5mm the pad in my PCB, but the manufacturer told me they want to increase the cost because it is difficult to fabricate. But i think my design is correct. Any advice?
Electronics Forum | Fri Sep 01 19:54:31 EDT 2017 | tmennink
What was the outcome OrHorti after baking some? In the end we went with a different machine (Fuji NXT) which was able to get the leds out of the reel. After switching we still face a loss of about 0.5% but it is acceptable for now.