Electronics Forum | Tue May 02 16:04:44 EDT 2006 | Giovanni Lorenzini L�pez
We are looking for 3 used FIFO buffers in operational conditions model PB-0.6M-9, FOB Puerto Rico. Any informationplease contact Giovanni Lorenzini my e-mail adress is glorenzini@lutron.com
Electronics Forum | Tue May 02 16:05:35 EDT 2006 | Giovanni Lorenzini L�pez
We are looking for 3 used FIFO buffers in operational conditions model CTI Conveyor Technologies PB-0.6M-9, FOB Puerto Rico. Any informationplease contact Giovanni Lorenzini my e-mail adress is glorenzini@lutron.com
Electronics Forum | Tue May 02 16:11:50 EDT 2006 | jdengler
Use the Equipment Mart at left side of this page!
Electronics Forum | Fri Nov 07 01:01:55 EST 2008 | mskler
What should be stencil size to reball the BGA of 0.6MM ball dia.
Electronics Forum | Mon Jun 19 10:30:30 EDT 2023 | smtusa
Jet printing can reach 80um, whereas contact dispensing is 0.3mm I believe. 0402 pads are 0.6x0.5mm.
Electronics Forum | Sat May 29 06:07:16 EDT 2021 | rsatmech
Thanks, I do observed more solder paste terms of percentage in 0.06mm stencil than in 0.08mm stencil.
Electronics Forum | Thu Mar 10 06:16:37 EST 2011 | ravo
I am asking if I can assemble BGA components with my machine QP242. My BGA spec : WIDTH * LENGTH = 27*27 MM PIN DIAMETE = 0.6 MM Thankd in advance.
Electronics Forum | Tue Apr 26 05:04:10 EDT 2005 | siverts
Sorry for my blackout, but here it comes: Solder paste: Senju 7100-GRN360-K1MK-VS Sn 95.5 Ag 3.9 Cu 0.6 Solder wire: Kester 24-7040-8834 Sn 96.5 Ag3.5 Regards,
Electronics Forum | Sat Dec 10 07:03:59 EST 2005 | mdemos1
Hi. I am trying to find out the minimum copper thickness I should see on a through hole barrel. The board has 1 ounce copper and the board thickness is 0.062". I am finding thicknesses of 0.6 to 1.2 mils. Thanks, Mike.
Electronics Forum | Wed Mar 14 13:52:11 EDT 2007 | Oswaldo Rey
Vias are thru hole, pcb is two sided, bottom copper is 2 sq inches, vias are 0.6mm diameter. thanks,
winsouce.jpg)
