Electronics Forum | Wed Mar 03 07:54:37 EST 2004 | stefwitt
According to inquiries of splicing tape, it is been done at many places. I do agree that the feeder fouls badly, if the splice brakes. How much longer does it take to fix the problem with a broken splice? How quickly can you change a feeder/tape with
Electronics Forum | Wed Aug 12 17:57:32 EDT 2020 | glasscake
Due Diligence Post: Figured out my issue with the laser itself, it was set up in RS422 mode and it should have been setup in 0-10v analog out. As far as actually using the tools i have not got that far yet but I will DD again when I get that far. I
Electronics Forum | Sun Jun 30 04:25:57 EDT 2024 | sarason
There is a Chinese software product called "Programming" from Ealead. https://ealead-e.ucoz.com/index/eps/0-10 The Ealead software makes spliting your product over a multi-machine line, even if they are not from the same manufacturer easy! My soft
Electronics Forum | Wed Apr 10 22:23:48 EDT 2002 | davef
IPC-6012A, 3.4.1 has words to the effect of: Hole size tolerance and hole pattern accuracy shall be as specified in the procurement documentation. Our fab says: Standard Drill Sizes Drill Number ||Hole Size ||Finished Hole Size 70 ||0.028" ||0.02
Electronics Forum | Wed Apr 10 22:24:30 EDT 2002 | davef
IPC-6012A, 3.4.1 has words to the effect of: Hole size tolerance and hole pattern accuracy shall be as specified in the procurement documentation. Our fab says: Standard Drill Sizes Drill Number ||Hole Size ||Finished Hole Size 70 ||0.028" ||0.02
Electronics Forum | Wed Aug 21 17:44:32 EDT 2002 | davef
Splitting hairs, I expect SIR of all solderability protection, including OSP, to decrease after reflow. What�s more, I expect the SIR of all solderability protection to pretty much decrease over time. The �comb pattern� test specimens meet requirem
Electronics Forum | Wed Mar 14 18:29:04 EST 2001 | mparker
The basic rule of thumb (info current as of 9/2000, from Ceeris and others) is the 10X multiplier for each major process step. Catching a defect and correcting in SMT will cost $0.10 each. (think about $.04 placement cost, stop line time, operator h
Electronics Forum | Fri Dec 12 11:52:59 EST 2003 | Marc Simmel
I have encountered problems with a 90/10 tin-lead plated SMT component wicking all the solder paste off the pads on the substrate. Worst, the defect occurs randomly - adjacent leads may have 'good' joints, though heel fillets are poor. The solder pa
Electronics Forum | Fri Dec 09 05:03:35 EST 2005 | rlackey
Hi, I'd be inclined to go with the through hole capacitor, as to surface mount it you would probably need to go for an elco (ceramics & films don't do that value in that voltage, & you'd be hard pressed to get a tant in that voltage). SMD Elcos a
Electronics Forum | Mon Jan 21 21:12:11 EST 2008 | davef
Calculate numbers according to your situation, as follows: Cost = Cost per kilowatt hour x [Amps x volts x hours of operation � 1000] Cost per kilowatt hour: What we need to do to figure out the total cost is get out our electric bill. Look on the
