Electronics Forum | Thu Dec 18 08:18:48 EST 2014 | kevinb
Does anybody know what material is used for over molding I/Cs. I would like to find a material that others use to mold there electronic components. I am wire bonding and mounting a small cap (0201) on an FR-4 board. I need this material to withsta
Electronics Forum | Thu Apr 19 15:22:34 EDT 2001 | jdtpfacreate
Spanky, It sounds like you are looking for a recipe to use when you do get an assembly in that has 0201's on it. We have worked with our customers worldwide in the development of the process to use 0201's. Most equipment manufacturers out there
Electronics Forum | Thu Apr 19 21:49:29 EDT 2001 | davef
SCREENING... 1. Is type 4 paste necessarily required? [No, not unless you are using it for some other purpose.] 2. Is No-Clean Ok to use? [YES] 3. How thin stencil is required? 5 mils? [5 is OK, but I wouldn�t base the decision on the 0201. 6 mil is
Electronics Forum | Wed Jun 20 12:07:13 EDT 2001 | Steve
I would suggest getting a copy of IPC-SM-782A, Surface Mount Design and Land Pattern Standard, and IPC-7525 Stencil Design Guidelines. My experience is that reflow does not cause tombstoning very often. Pad and land design, paste volume, and placemen
Electronics Forum | Thu Sep 29 19:18:24 EDT 2005 | HLy
Hi, I noticed that the solder joints on my BGAs end up with a lot of wrinkles after reflow. See picture at: http://pstr-r02.ygpweb.aol.com/data/pictures/02/01A/17/DD/E3/9E/n8BhepQLFDs6GMSwaRNxPCTWR5NdpUJZ0300.jpg Does anybody have any ideas what cau
Electronics Forum | Wed Sep 17 05:41:16 EDT 2008 | ralphspm
Can Fuji machines such as IP1 and IP2 utilise 2mm pitch feeders provided by Hover-Davis? Has anyone used them on an IP1 or IP2, and if so were they effecient? Does anyone have 2mm pitch feeders that utilise an Fuji IP1/IP2, for sale? We are currently
Electronics Forum | Fri Aug 16 09:35:54 EDT 2013 | leemeyer
I am doing some research on Pick and Place machines and have found the Samsung brochure a bit confusing. Specifically I am looking at the SM421, some of the information I am finding states that this machine is spec'd to place 0201 and up. On the same
Electronics Forum | Mon Jun 18 13:29:34 EDT 2001 | nifhail
What is the recommanded profile for board which consist of 0402 & 0201 comps. to reduce the effect of tomb-stone. Slow ramp rate ? how slow is considered as slow. Soak time 60 or 120 C,at which end should I stick to? what is the best time before reac
Electronics Forum | Thu Dec 18 13:07:50 EST 2014 | kevinb
I have worked with Epoxy Technology in the past with silver epoxy. Just to fill you in on what I have been doing with this project in the past. I was using a silver epoxy for my 0201s. I then over molded with an epoxy with a dam and fill. Then th
Electronics Forum | Tue Oct 11 19:57:04 EDT 2005 | hly
Hi folks, I had posted this earlier but I think there was some confusion on where the wrinkled joints were. The picture is the side view of a BGA soldered onto the PCB. I was able to take this picture becuase the BGA was at the edge of the board. I
.gif)
