Electronics Forum | Fri Feb 22 09:10:51 EST 2008 | mulder0990
AJ, You can use 0402 feeders to place the 0201 parts. I would suggest getting the feeders you are going to use calibrated before trying to run the parts. Also, another good idea is to get some 0.4mm tape leaf covers for the feeders. They will h
Electronics Forum | Wed Feb 27 15:14:52 EST 2008 | gregf912
Senior, below, is correct. THe narrow view camera has to be upgraded in order to place 0201 components. Also to pick the parts you need the 0201 feeders. These feeders present the part 0.3 mm higher than the standard 0402 feeder. The part pickup heig
Electronics Forum | Fri Feb 22 13:24:24 EST 2008 | mulder0990
How did I know senior was going to get in here too. Nice to see you again. I figured as much with the height difference, but I do not have the equipment here to test my thoughts. We somehow have our machine dialed in to run the 0201 parts with W
Electronics Forum | Fri Feb 22 10:46:04 EST 2008 | mulder0990
Yes, we have. We do have one machine that can place the 0201 parts. I have bought some 0.4mm tape leaf covers and replaced the 0.7mm covers on some CP6 0802 feeders. I calibrate the feeders as tight as I can and make sure the feeders that we use a
Electronics Forum | Fri Jun 22 11:54:47 EDT 2001 | jdtpfacreate
OEM Boy, This is an excellent question. Since I am on the "I-want-to-sell-you-equipment-side" I do not have the hands-on experience that you do but, I do have a many engineers back at our factory who have dedicated their lives to these issues.
Electronics Forum | Wed Feb 27 04:23:13 EST 2008 | fujillews
Hi It is best to fit the VGA camera for 0201 parts make sure your software is high enough..above v1.33 although you can place without but no so good. 0.4mm tapered nozzles are best. 0201 feeder the locator base in increased by aprox 0.3mm and the ind
Electronics Forum | Thu Jun 14 23:21:30 EDT 2001 | oem boy
I am working on 0201 development for my company in the UK, and I am planning a rather extensive DOE for my reflow oven profile. I am planning on studying various ramp rates, soak times, times above liquidus, peak temps, etc... My biggest concern
Electronics Forum | Tue Sep 14 19:19:23 EDT 2021 | dwl
Just for grins, try rotating the board 180 degrees before reflow. this might allow both sides of the part to reflow at the same time. Is it just that one part with the arrow? Its interesting that none of the other parts have the same issue despite a
Electronics Forum | Wed Sep 15 19:01:39 EDT 1999 | DGrenier
| | I'm hoping to use 0201 caps and resistors in a new design but so far have only found one company who makes such small devices (Murato). | | | | Can anyone direct me to any other supplier? | | | | Are there any particular problems associated wi
Electronics Forum | Mon Sep 13 17:39:02 EDT 2021 | duchoang
Agree. The big pad and part nearby made the paste on two ends of cap melted unevenly.Deposit more paste on the tombstone-ed pad will make it easier to melt. Nothing wrong with profile if everything else is OK. BTW, how to measure temperature on two e
