Electronics Forum | Thu May 04 14:59:02 EDT 2023 | davef
Review technical papers on 0201s in the Express Newsletter published today: - https://smtnet.com/express/
Electronics Forum | Tue May 02 07:50:41 EDT 2023 | wippsen
Hello, who is printing 0201 apertures or smaller and can provide information on stencil design, stencil thickness and type of solder paste?
Electronics Forum | Thu May 04 20:33:12 EDT 2023 | stephendo
Are you talking imperial or metric? A metric 0201 is three sizes smaller than an imperial 0201. The paper describes metric 0201 as about the size of a grain of sand. That would be pretty fine sand.
Electronics Forum | Thu Jun 14 23:21:30 EDT 2001 | oem boy
I am working on 0201 development for my company in the UK, and I am planning a rather extensive DOE for my reflow oven profile. I am planning on studying various ramp rates, soak times, times above liquidus, peak temps, etc... My biggest concern
Electronics Forum | Sat Sep 11 13:49:13 EDT 2021 | kojotssss
Most common causes of tombstoning in our factory: small amount of paste printed on the pcb, improper placement ( pick up process, picked up on the component metallization- large cavity in reel).
Electronics Forum | Tue Sep 14 19:19:23 EDT 2021 | dwl
Just for grins, try rotating the board 180 degrees before reflow. this might allow both sides of the part to reflow at the same time. Is it just that one part with the arrow? Its interesting that none of the other parts have the same issue despite a
Electronics Forum | Mon Jan 03 14:00:06 EST 2000 | John Anderson
Has anyone had luck with 0201 cap board design, solder printing and reflow? IPC-SM-782 does not provide much help. I am particularly interested in attach pad design, stencil aperture design and thickness, solder paste (mesh, metal content, etc.), and
Electronics Forum | Tue May 06 11:26:52 EDT 2014 | aj
Hi all, Can anyone share the necessary info for printing 0201's? stencil Thickness, grade of steel, 1:1 etc Thanks in advance, AJ
Electronics Forum | Thu Oct 03 18:45:56 EDT 2002 | davef
Get started with an "On-Board Forum" [blue bar an inch down from the top of the page] moderated by Jeff Schake at DEK that was a discussion focused on stencil printing issues with 0201 technology. Chris: Are you putting 0201 on flex? If so, sounds
Electronics Forum | Wed May 07 08:16:58 EDT 2014 | emeto
It really depends on pad design and other component on the PCB. Most of the time I run 0201s I have microBGAs on the board and usually print 3mil. Reduction will depend on the paste. For leaded paste you will have reduction (about 10% or so).For Lea
.gif)
winsouce.jpg)