Electronics Forum | Mon Jul 24 08:17:06 EDT 2006 | nodlac
Northeast Machines- For a machine that is 16 years old the best thing to do is contact Suzuki direct. I asume it is a TAB Machine. I know most of the time people hate to be refered back to the OEM but in this case it is best. www.suzukinet.co.jp For
Electronics Forum | Thu Apr 29 17:52:33 EDT 2021 | mike_infl
We have an assembly which we are trying to machine pick and place a Mil-Max pin that is .020 dia placed in a .026 hole. The board is .1125 thick. We have to place 106 of these pins. Without going into the challenge of getting proper hole-fill to me
Electronics Forum | Mon Feb 28 17:16:38 EST 2000 | Stu Leech
We just got a lesson on the effectiveness of heat sealed metalized vapor barrier bags. A customer sent us two bags of 100% saturated PBG components by air freight. This was for a demoisturizing test. When we found the devices 80% dry when they arrive
Electronics Forum | Mon Feb 28 17:16:38 EST 2000 | Stu Leech
We just got a lesson on the effectiveness of heat sealed metalized vapor barrier bags. A customer sent us two bags of 100% saturated PBG components by air freight. This was for a demoisturizing test. When we found the devices 80% dry when they arrive
Electronics Forum | Thu Dec 29 11:28:14 EST 2005 | DannyJ
Measurements: Block is .680" x .680" x .125" 4 dowel pins: .026" diameter x .250" length Center to center measurements on block where dowel pins are inserted: .600" x .600" Let me know if I can be of any more assistance. Dan
Electronics Forum | Fri Apr 27 08:19:04 EDT 2012 | jim_n_hky
Can anyone offer guidelines on DFM and process recommendations for soldering .050" pitch connectors in the wave. The initail design had .026" drill with .043" pads so only .007" between pads. I requested .035" pads, but this still only leaves .015" b
Electronics Forum | Tue Mar 16 18:11:54 EDT 2021 | grahamcooper22
I am wondering, I have an application for assembling a 0.4mm WLCSP to a pcb....the solder sphere size is 0.26mm...would you print paste in the normal printing process and then place the device and reflow...or would you use a fluxing station on the pi
Electronics Forum | Tue Aug 04 12:32:13 EDT 1998 | Bob Willis
The design rules for solder thiefs are that the extra pads must be bigger than the proceeding pads to be worth while as a minimum guide the pad is 3x the size of the proceeding pad so if the pad is 0.030" the thief would be 0.090" wide. As steve has
Electronics Forum | Tue Dec 27 09:39:36 EST 2016 | westshoredesign
Thank you for the reply, MPMEng. I received the Speedline UPG-026/27, but it actually came with the incorrect mouse. Since original post I've contacted seller, received correct mouse, successfully installed drivers, encountered a new issue. At thi
Electronics Forum | Thu Jan 10 22:55:24 EST 2002 | davef
You are sure taking you sweet time getting this thing running. You're getting too much beach time. NOZZLE SELECTION Typically, the only rule of thumb that applies to choosing the correct nozzle ID is that it should be one half of the required dot d
