Electronics Forum | Tue Jun 07 15:00:10 EDT 2005 | glenda
what about spacing between pads center to center on 0402.
Electronics Forum | Wed Jun 23 18:23:32 EDT 1999 | Tom B.
Even though you may find a pad-pad thru-hole spacing, part body size, orientation, and insertion head tooling clearences may be the deciding factor in spacing. 1. Part body diameter will dictate component centroid spacing. ---[][][][
Electronics Forum | Wed Jun 23 15:49:30 EDT 1999 | Kelly Morris
In the IPC-SM-782 (Surface Mount Design and Land Pattern Standard) it recommends a minimum of .040" between bottomside wavesoldered chip pads. Where might I find a similar IPC recommendation for minimum space between thru-hole pads? Does anyone kno
Electronics Forum | Wed Apr 15 17:16:00 EDT 2009 | rmitchell
Hi, I am trying to reduce some 0402 cap tombstones. The main cause is the pad spacing is a little too far apart and the parts are as tall as they are wide .5mm I am stuck with the pad spacing for a while. All other parts are soldering well, even 0
Electronics Forum | Thu Feb 24 11:02:29 EST 2000 | mark scheunemann
I am looking to discuss 0402 issues, specifically tombstoning/unsoldered. Any recommendations on pad size/spacing, stencil design etc would be helpful. Placement and reflow profile look good.
Electronics Forum | Thu Feb 24 11:02:29 EST 2000 | mark scheunemann
I am looking to discuss 0402 issues, specifically tombstoning/unsoldered. Any recommendations on pad size/spacing, stencil design etc would be helpful. Placement and reflow profile look good.
Electronics Forum | Fri Apr 17 10:44:29 EDT 2009 | rmitchell
Hi, follow up, Thanks to everyone that responded. We finished the build, the sun burst thru the clouds and the birds sang. Well that was a slight exageration. Sorry for lack of detail on the original post, I was frazzled. Since the 0201's were p
Electronics Forum | Wed May 09 17:26:57 EDT 2001 | davef
Awww, don beso tuff on ursef!!! It sounds like you�re thinking correctly with what you�ve done, but it�s possible that the test you ran did not represent your actual production environment as well as you would have liked. So, you just need to "cran
Electronics Forum | Wed Jul 14 21:34:16 EDT 1999 | karlin
| | | | | Hi, | | | | | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | |
Electronics Forum | Thu Jul 15 14:38:38 EDT 1999 | JohnW
| | | | | | Hi, | | | | | | | | | | | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants)
