Electronics Forum | Sat Jun 12 04:06:33 EDT 2004 | Steve
Hi, Anybody has the experience or information of mounting the SMD 0402 on solder side of PCB by adhesive (apply by stencil printing) and then wave solder the 0402? Best regards.
Electronics Forum | Wed Jan 07 05:53:05 EST 2009 | sm2009
Hello, does anyone know if it's possible to wave solder 0402 components? Are there drawbacks? Where can I find technical details about recommended footprint and glue point? Last question: are there suggestions about wave soldering for ic with 0,635mm
Electronics Forum | Wed Jan 07 07:50:24 EST 2009 | ludee_circuits
I think so. My customer once assembled resistors 0402 ,by Glue+wave soldering process. But PCB must be printed soldermask bridge between 0402 SMD PADs, otherwise you would encounter short problem. Sorry I don't have any comment for recommended footp
Electronics Forum | Wed Jan 14 06:41:08 EST 2009 | andrzej
I did not tried this before (never hada chance to do it) but I considered such option - maybe try using temporary wavesolder mask on such small components. Run both sides of PCB through SMT oven and then mask 0402 completely and go with wavesoldering
Electronics Forum | Mon Jan 12 02:45:53 EST 2009 | sachu_70
Hi Stefano, Although your concept of Wave soldering such devices is possible, I would look at an alternate solution. An easier way would be to Reflow solder all Bottom side SMD components with solder paste, followed by wave soldering for only through
Electronics Forum | Thu Jan 15 03:20:59 EST 2009 | sachu_70
Hi Andrzej, I guess you mean peelable solder resist. Good idea to try during R&D, but certainly not a solution on production floor. Also, few constraints to be considered such as presence of entrapped air between component and solder resist, the natu
Electronics Forum | Thu Jan 15 12:31:06 EST 2009 | wavemasterlarry
Well I finally got the power turned back on at my house. Guess they only let ya slide so long without paying the bill. I still say 4 months is OK - especially inthe winter time. But requardless, wave soldering 0402s is nuts. Getting adhsive to fi
Electronics Forum | Mon Jul 12 21:05:06 EDT 1999 | karlin
Hi, I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) Secondly, I need also facing a lo
Electronics Forum | Thu Jul 15 16:15:13 EDT 1999 | Doug
| Hi, | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | | Secondly, I need also f
Electronics Forum | Mon Jul 12 21:40:56 EDT 1999 | Earl Moon
| Hi, | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | | Secondly, I need also f
