Electronics Forum | Mon Jan 12 02:45:53 EST 2009 | sachu_70
Hi Stefano, Although your concept of Wave soldering such devices is possible, I would look at an alternate solution. An easier way would be to Reflow solder all Bottom side SMD components with solder paste, followed by wave soldering for only through
Electronics Forum | Thu May 19 02:04:36 EDT 2016 | jpcwg
Located in Shenzhen China, the Silicon Valley of hardware, ALLPCB.com is a company specialized and experienced in manufacturing printed circuit boards of prototyping and low volume production. Through the years thousands of business customers and eve
Electronics Forum | Tue Dec 04 08:34:07 EST 2007 | davef
We no advice to give you on the topic, but maybe while you're waiting for others to reply, reading a trade journal article on the topic might help. Below is a link to "Pin-in-hole reflow (PIHR) and lead-free solder joints" by David Bernard, Bob Willi
Electronics Forum | Wed Jan 30 01:54:14 EST 2013 | onix45
Hello, I am a student and i am having problems with understanding a certain pcb design. You can find the pcb here: http://pdf1.alldatasheet.com/datasheet-pdf/view/449682/TI1/LMR62014.html What i don't understand is if the pcb is just routed normall
Electronics Forum | Tue Jan 28 15:00:22 EST 2025 | klauss
I want to place a connector near the edge of a PCB using a Panasonic Pick and Place machine. One-third of the connector (the part with the smd pads) sits on the PCB, while the remaining portion hangs off the edge. When the connector isn't seated prop
Electronics Forum | Wed Jan 29 13:23:37 EST 2025 | carl_p
Ideally need to understand the board & part more. I place parts through the board with a Panasonic AM100 & standard nozzles. I just had a custom tray made to hold the parts for pick up...
Electronics Forum | Mon Jul 14 02:17:07 EDT 2003 | jojojameson
Hi, We have a complete solutions in electronic manufacturing (SMT & Through hole).Please give your requirement to us we will give you the best offer. Regards Jojo Jameson
Electronics Forum | Sun Feb 02 07:46:56 EST 2025 | peakingtech
Consider SMT red glue (SMT adhesive) in that situation to fix the connector. However that may complicate the process because of additional operational steps.
Electronics Forum | Mon Feb 03 18:48:45 EST 2025 | tey422
You might want to order the SMT fixtures with clamp(s) similar to the one I attached. Just make sure before sending the board into reflow oven that the connector is clamped straight and aligned.
Electronics Forum | Fri Feb 14 14:38:44 EST 2025 | linux
We have experience with a lot of these components, It does come down to the connector type you are placing, I would need the connector spec to assist you.
