Electronics Forum | Thu Apr 26 18:39:45 EDT 2001 | jagman
I'm looking for information (links) to pad design and layout spec's for different sized passive SMD's. To be specific, 0603, 0805, 1206 and 3216 sized parts. I'm most interested in finding out about land spacing between two parts. What is accepabl
Electronics Forum | Thu Aug 23 15:45:48 EDT 2001 | slthomas
So, we've already addressed the tombstoning on these guys by adopting the mfr's (Pana.) recommendations for pad size and spacing. Problem is, we have pretty bad wetting of some of these parts. The rest of the board we use them on looks great, nice
Electronics Forum | Sun Nov 10 16:07:31 EST 2013 | davef
First, require use of the IPC-7351B Standard as the sole basis for laying-out pads on circuit boards. Second, if someone wants to use a pad design that either: * Wasn't covered in IPC-7351B ... OR * Was for a component that was in the standard but
Electronics Forum | Mon May 08 08:54:28 EDT 2000 | Lee Radney
Ok... Anybody got any quick, low cost ideas that can help me here? We run various panel layouts (all products are same width) thru our reflow oven. The problem is that due to the different layouts of our panels, the moveable center support chain
Electronics Forum | Thu May 11 17:28:40 EDT 2006 | bradlanger
Steve, We have had the same problem at my company and unfortunately I do not have any good news for you. We are using a pizza slicer type depanalizer from FKN and if the MLCC caps are layed out too close to the edge they still break. We had to add th
Electronics Forum | Tue Aug 25 20:44:16 EDT 1998 | Peter
We haven't built these yet. The customer was in layout at the time and I was looking for any flags from others to determine if I should have them change the layout as I've not seen this before. From your response and others that I've received, it s
Electronics Forum | Wed Mar 25 17:11:20 EST 1998 | Mcox
| We are having some problems with "drawbridging" on 0805 film capacitors. | We have already reduced the pad width from .050" to .040" based on input | from vendor. Defects appear to be random as far as location on the PWB and direction | of placem
Electronics Forum | Tue Jun 13 17:16:44 EDT 2006 | slthomas
"I believe I was the one who stated in an old post that prying the leads is rediculous." I have been down this road as well. The prez of my previous employer decided that because he could pry .012" leads off the pads with a screwdriver that we had a
Electronics Forum | Mon Jul 02 20:13:41 EDT 2001 | davef
We agree with Wolfgang. Adding points along his line of reasoning: * Also consider placed component prescience. Sometimes, a mis-pick results in paste on the nozzle, which leads to the next component being stuck on the nozzle and not placed, which
Electronics Forum | Wed Mar 25 19:31:13 EST 1998 | Earl Moon
| | We are having some problems with "drawbridging" on 0805 film capacitors. | | We have already reduced the pad width from .050" to .040" based on input | | from vendor. Defects appear to be random as far as location on the PWB and direction | | o
