Electronics Forum | Tue Mar 03 09:05:52 EST 2015 | bandjwet
We are in need of a small SMT printer able to double sided boards with an emphasis on fast changeover and the ability to have board supports. Our typical lot size is 1-20 pieces of rigid boards with technologies down to 0.5mm pitch and 0201's.
Electronics Forum | Wed Feb 26 11:06:27 EST 2003 | slthomas
Always a joy to see a stencil cleaner thread get opened up....lots of varying opinions as to what's needed, best, environmentally sound, etc. We use an ultrasonic batch cleaner that uses a detergent (dilute to 1:10 or 1:20, can't remember), then bo
Electronics Forum | Wed Aug 25 22:55:59 EDT 2004 | pdeuel
We started placing 0402 with regular feeders and wasted every other part untill we got the correct feeders. The cost for most parts runs less than 1/20 th of a cent. Reels come in quanities of 10,000 instead of 5,000. You will also need the correct t
Electronics Forum | Wed Mar 27 12:17:46 EDT 2019 | jstebbs89
Hello lads. I run a Sequencer 2596 and have had good luck. Just recently it sounds like air is not making it into the machine. With the machine palmed down it has the required 55-60psi going in, when I release the Estop the psi drops to about 30 and
Electronics Forum | Fri Apr 22 18:17:14 EDT 2022 | swilson
Hello I experiencing major misalignments. I am using a Nichia LED package size@ y=.086,x=0.33mm, with recommended solder pad pattern x.086mm, y=.033. Note here is the kicker the PCB pattern does not meet this requirement. The PCB pad landing is based
Electronics Forum | Wed Aug 24 08:03:17 EDT 2005 | james
I need some help here. I just to see what suggestions anyone else has. Our Man. Eng. has 3 profiles on our 9 zone Heller Reflow oven. These are the profiles: 1. 120 140 150 150 180 200 215 250 220 29in per minute 2. 120 130 145 150 150 185 20
Electronics Forum | Mon Nov 07 15:05:16 EST 2011 | tpappano
Hi Jeff, This machine (my unit #2) has a couple programs that execute just fine, but when I added additional mounts to one of them I got the "120"error. When I added another new program, the "118" error showed up, and of course, everything in all t
Electronics Forum | Tue Oct 06 14:29:14 EDT 2015 | cadco
Update 6 Oct 15: We have completely re-configured the oven PID boards such that everything is now visible on the oven by the s/w and all is now OK since the "Machine"card is now recognized. We have just one additional procedure to do and that is to
Electronics Forum | Sat Oct 03 21:36:33 EDT 2015 | cadco
Update 6 Oct 15: We have completely re-configured the oven PID boards such that everything is now visible on the oven by the s/w and all is now OK since the "Machine"card is now recognized. We have just one additional procedure to do and that is
Electronics Forum | Mon Aug 24 10:26:39 EDT 2015 | derrikf
I've recently pushed the company I work for to switch to a halogen-free solder that our supplier carries, Kester's NP 505 HR, prior we were using Kester NXG1. NP 505 HR performs great on the screen, we have a lot of down time in between prints (we d
