Electronics Forum | Tue Sep 12 20:10:09 EDT 2006 | davef
Russ: You say, "I will almost guarantee that a 1/4- 20 nut will remove part during reflow if it will fit." What are you talking about?
Electronics Forum | Wed Sep 13 10:49:07 EDT 2006 | slthomas
1/4-20 would be unlikely to fit on an 0603 is all. I have to admit that when he first brought up the hardware theme I kept visualizing a jack screw assembly but the results I envisioned were less than ideal.
Electronics Forum | Wed Jan 31 08:26:36 EST 2007 | geb
I think it might be the feeder banks, that is causing the problem. I've tried picking a SOT-23 component using head 2 spindles 1-4 from a rear feeder bank and it is picking off centre. Doing exactly the same, but putting the feeder in a front bank it
Electronics Forum | Wed May 02 11:54:26 EDT 2007 | aj
Hi All, Anybody placing the above mentioned component ? http://www.datasheetcatalog.net/datasheets_pdf/C/M/1/4/CM1422-03CP.shtml If so , any do's & dont's would be appreciated. aj...
Electronics Forum | Tue Jun 19 17:16:44 EDT 2007 | jseagle
Hi all, Nevermind, I found them on my own for 1/4 the price. I am looking for a source for the Aquastorm Blower Filters. I have a price from the blower manufacturer but I think it is quite high. Thanks James
Electronics Forum | Mon Aug 20 07:31:26 EDT 2007 | dilogic
We have GSM1 running on USOS V1.4.14. Is there a way to change default light levels for PEC (down looking camera) during feeder teach? Whatever I tried, it is always set to some default level... - Dejan
Electronics Forum | Mon Aug 27 14:23:45 EDT 2007 | scooter
I must be missing something? If you strip 1/8" off both ends of a 1/4" long wire you would have nothing left? Anyway I would use buss wire and if needed slide a bit of tubing over it bill
Electronics Forum | Fri Dec 07 14:44:35 EST 2007 | actech
I have ordered 3/16th and 1/4 from McMaster Carr in the past. you buy it bulk cut it at an angle and melt it together. I think its Mcmastercarr.com and look into belts or conveyor belting you should be able to find it online there.
Electronics Forum | Fri May 15 22:06:10 EDT 2009 | jrr3434
I use a clinch of 5 and a length of 3 for 1/4w and thicker leg diodes probably a 7 and 5. You really just have to play with the machine it figure out what works best for your application.
Electronics Forum | Wed Jun 07 23:57:22 EDT 2017 | marcelll
Hi, Try to find replacement edge belt pulley for old PCT conveyor. Any idea where to find a supplier to buy small pulley for 1/4 inch edge belt ? Thanks