Electronics Forum | Fri Nov 04 17:50:52 EDT 2016 | ttheis
We have a vip oven with corrupt installation apparently but still have the configuration files. Looking for 1.05e install disks if any one has a copy to fix it. Thanks
Electronics Forum | Fri Nov 04 17:51:31 EDT 2016 | ttheis
I contacted btu but they told me they only have wincon version 2.0 and newer.
Electronics Forum | Fri Oct 28 17:50:17 EDT 2016 | ttheis
Found a broken wire in the data line and I thought that was it for sure but was not. Checked continuity of the data cable and it is ok now but still no comm. The embedded controller status window shows "send failures" but no "reply failures." Winco
Electronics Forum | Mon Oct 29 15:58:47 EST 2001 | davef
Kitting: Buy-in material in kit form that is complete and in the proper form. Line set-up: Layout all boards to be the same width. Printer set-up: Use a dispenser, instead of a printer. Dispenser set-up: Program & debug off-line. Placement machin
Electronics Forum | Mon Apr 18 18:23:41 EDT 2022 | youngbuck
Hello everyone, We have a Siemens HS50 error going on as soon as we boot up. It shows message saying "Machine is in test mode." Cause: Initalizing gantry axes. Start Sitest and check machine (firmwre versions,configuration, etc. It will try to refere
Electronics Forum | Sat Dec 10 22:41:41 EST 2016 | ttheis
Hi Ray, BTU was not too helpful with me because we bought the machine second (probably third or fourth) hand. I bought some FCU's from Ed at Assured Technical Services (assuredtech@yahoo.com) and a hard drive that had the Wincon software we needed.
Electronics Forum | Sat Aug 29 08:43:35 EDT 1998 | Dave F
| Hi, Friends, | Could you please recommend me some solder mask materials and equitements for high quality solder mask? Details such as company name, phone numer et al are welcomed. Thanks! | Have a good day | Xingsheng Xingsheng: Consider the follo
| 1 |
.gif)
winsouce.jpg)