Electronics Forum | Thu Oct 01 13:33:01 EDT 2015 | marlyn
Hey there fellow people with SMT > issues... What's the proper procedure for > soldering through-hole headers on the back-side > of the PCB (pins poking out on same side as SMT > parts)? ( Yes - I did the SMT side first and am > now faced with L
Electronics Forum | Tue Sep 29 11:49:02 EDT 2015 | spoiltforchoice
Typically - hand soldering as you are currently doing. Should your volume justify it you can invest in a selective soldering solution, these might take the form of a robotic arm that essentially replicates manual soldering or a solder jet similar to
Electronics Forum | Tue Oct 27 14:28:00 EDT 2015 | swiese242
I would suggest investing in a selective solder machine as well. This has saved us on a ton of labor and headaches. The customized brackets for the wave is not cheap. I would first check auctions to save thousands...
Electronics Forum | Tue Sep 29 11:37:52 EDT 2015 | robl
Hi Marlyn, We use durastone pallets over a wave - so areas machined out so the solder can get to the pins but not the SMT. You can also get fancy selective solder machines, but I'm guessing that as you're asking you haven't got one. Hope that help
Electronics Forum | Thu Jul 20 14:52:05 EDT 2000 | Bob Willis
If you are talking about Pin In Hole Reflow that is not true, I hope it was not my friends at Speedline that told you that. Stencil printing of paste for through hole reflow can be done. If you get all the parameters right it can give you joints lik
| 1 |
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang， Fuhai Street，Fuyong
Shenzhen, 30 China
Phone: 13713862102
