Electronics Forum | Wed Feb 28 14:41:31 EST 2001 | davef
http://www3.uic.com/852568c80050acb1/9d77f80a90bd656c8525692700744d90/a87e35634983d6458525697d005f8a01?OpenDocument
Electronics Forum | Tue Jul 30 10:16:25 EDT 2024 | jergod
Yes, i found program from earlier posts. thanks. Yes, seems like it doesnt work for references like C1-9 etc. But for me it seems to be good enough for most of cases!
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Wed Oct 06 03:18:01 EDT 2004 | Joseph
Dear all, Recently our customer complaint that some components being came off from the pcba after dropping test.But the curious is, the leads show visible solder fillet covering more than 75% of termination area on pad, which is acceptable as per IP
Electronics Forum | Tue Sep 18 13:58:01 EDT 2001 | ert002
50%) only over the appertures where there was poor support. Most prints took 2 knead strokes to print OK, but this caused fine pitch leaded devices to almost short. stencil had to be be wiped after kneading. 2 similar devices with exactly the same
Electronics Forum | Mon Aug 08 16:14:36 EDT 2011 | wmburke
We are building a plasma diagnostic to monitor MHD phenomena in tokamak. As part of the development, we need high-voltage, high-power RF capacitors to tune and match an inductive load. This application is similar to a small induction heater, with t
Electronics Forum | Mon May 07 12:18:06 EDT 2007 | wavemasterlarry
Nuts to that! Here's the right way todo this. I generally take a bill of Material and go line by line and charge accordingly. If there is a smt cap I charge 2.3 times the amount I pay, unless it�s a bigger than a 1206, then I charge 3.1 If it�s
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
| 1 |
winsouce.jpg)