Electronics Forum | Mon Jul 06 18:52:10 EDT 1998 | Dave F
Aside from process flows where the next step is: 1 Powering-up an assembly 2 Testing the assembly on electronic test equipment Is there a reason (need) to dry assemblies after water washing followed by a DI water rinse? Or is air drying OK? Dave F
Electronics Forum | Wed Feb 11 06:37:10 EST 2009 | reflowtechnologies
Please check the following: 1.Power supply. 2.SSR control power. 3.OTP or over temp protection at the software. Maybe you set it at low so it reads over temp even at lower temp. If still not ok you may check BTU service engineers. Brian Riggs
Electronics Forum | Mon Jan 06 11:07:20 EST 2020 | richardcargill
Ok.. ignore all the above, the X1 card has failed- nothing more. Can anyone recommend a supplier for a replacement ?
Electronics Forum | Mon Jan 06 14:02:00 EST 2020 | dman97
Have you tried to open the MINT program and re download the drivers to the cards? Sometimes the cards fail because the battery does not hold sufficient charge to keep the files intact.
Electronics Forum | Mon Jan 06 19:12:52 EST 2020 | dekhead
If you are unable to get to Diagnostics to exit to DOS; Try the following: ‘F5’ (WHILE STARTING MS-DOS) –OR ‘CTRL’ – ‘C’ (WHILE HIMEM IS TESTING EXTENDED MEMORY) Once in DOS, CDMINT Type LOAD to download MINTS from HDD to cards. DEKHEAD
Electronics Forum | Tue Jan 07 05:18:10 EST 2020 | richardcargill
Thankyou so much Dekhead, that worked perfectly. We're up and away again. I'm assuming the card just got it's data corrupted somehow. I'll know next time !!! Thanks again
Electronics Forum | Tue Jan 07 07:55:24 EST 2020 | dekhead
If it happened after holiday shutdown; good chance you have onboard battery going bad (battery dropped too low during extended shutdown). Replace batteries to alleviate future occurrence.
Electronics Forum | Mon Jan 06 11:41:52 EST 2020 | robl
JDT http://www.DEKHEAD.com if you are in the USA Adamtech http://www.adamtech.co.uk/contact.asp if you are in Europe There are some good Chinese suppliers, but a lot of Far East cards can be tarnished & with a reduced life due to running in a high h
Electronics Forum | Mon Jan 06 16:19:32 EST 2020 | richardcargill
haven't tried the MINT as it won't let me get that far !! Swapping the Eproms with card 1 and changing the identifier will let it get to the 'Press SYSTEM key' part of the startup though, then it fails on card 1 instead of 0 so I'll give that a try i
Electronics Forum | Wed Jul 14 12:03:53 EDT 1999 | greg c.
i have worked with the universal gsm in the past and am now helping out a contracting company who is setting up one in their facility. My question is: the power requirments for the machine calls for 3-phase 230V, does it really need 230V or is the s
.gif)
