Electronics Forum | Fri Nov 12 11:45:41 EST 1999 | Claude Couture
I use Aquanox SSA from Kyzen corp. No damage to stencils ever noticed. http://www.kyzen.com/index.htm
Electronics Forum | Wed Nov 12 11:18:13 EST 2008 | davef
Consider calling used equipment suppliers. Often, they keep the manuals for equipment in a "library" because they're unsure if they will get a manual with the next piece of that equipment they buy to resell. So then, they can make a copy to go with t
Electronics Forum | Wed Nov 12 11:19:15 EST 2008 | davef
Consider calling used equipment suppliers. Often, they keep the manuals for equipment in a "library" because they're unsure if they will get a manual with the next piece of that equipment they buy to resell. So then, they can make a copy to go with t
Electronics Forum | Wed Nov 12 11:10:46 EST 2008 | davef
We've talked about this previously. Seach the fine SMTnet Archive for threads like: http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=7911&#Message31319
Electronics Forum | Tue Nov 12 13:11:40 EST 2002 | steve
Your heating temperature is too low. Check your process and run the board through again. Then the graininess problem should go away. Or, try some different solder.
Electronics Forum | Sat Nov 12 12:16:11 EST 2022 | micropak
Furman, I am sorry I should have clarified earlier. I am from Pakistan. Asked your location just for information.
Electronics Forum | Wed Nov 12 09:39:11 EST 2008 | markhoch
Thanks Dave! I'm fighting the very same battle. Specifications are sparse on the subject, but you offer a very viable solution. (As usual!)
Electronics Forum | Wed Nov 12 16:04:11 EST 2008 | charliedci
I have about 8 pair of the 590 in use in thru hole production. Had to replace 1 set of blades because of overpressure (50psimax) and a valve over past year. They work well for light to medium work. The replacement blades were around $20.00.
Electronics Forum | Mon Dec 11 12:46:02 EST 2000 | Christopher Lampron
We too had a problem with the WS609. We have since switched to Alpha's WS619 (same formula with an anti-foaming agent) This really helped but we still monitor flux application and try to minimize wherever possible. Chris
Electronics Forum | Sun Nov 12 21:28:09 EST 2000 | Rchard Eigner
We are manufacturing a PCB that uses an integrated circuit that has a leg spacing of 10 mils, other components on the PCB are 1206's and 0805's. Is it possible to make the stencil apertures 10 mils apart or is there another way of making the stencil.
