Electronics Forum | Wed Jul 10 04:53:47 EDT 2002 | redmary
a leakage exists in the capacitor net (1206), which cause the voltage down so much. the process flow is: printing-placement-reflow-hand load-wave-depanel-FT. I find possible stress maybe exists in the depanel stage, does the extra stress cause the ca
Electronics Forum | Thu Dec 16 22:59:18 EST 1999 | Lloyd Nelson
Depending on the part say a cc1206 capacitor try a 7 degree theta rotation.
Electronics Forum | Tue Sep 19 18:06:05 EDT 2006 | lheiss
Does anyone know of a source for better documentation for the laser align settings? I managed to get a 1206 ceramic capacitor to measure and was working on a 1206 resistor and couldn't get it to succeed. I retried the cap and it failed again and ag
Electronics Forum | Wed Sep 09 21:20:26 EDT 1998 | Simon Ting
hi, 1206 capacitor with silver/palladium termination is mounted onto a ceramics substrates. Bonding is achieved through conductive epoxy. We discovered that the epoxy cracked and this caused missing capacitor. We had tried different grade of epoxy,
Electronics Forum | Thu Sep 10 09:47:15 EDT 1998 | Earl Moon
| hi, | 1206 capacitor with silver/palladium termination is mounted onto a ceramics substrates. Bonding is achieved through conductive epoxy. | We discovered that the epoxy cracked and this caused missing capacitor. We had tried different grade of e
Electronics Forum | Mon Mar 08 16:23:24 EST 1999 | Dave F
| Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? | | Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just
Electronics Forum | Tue Aug 30 15:39:37 EDT 2005 | esoderberg
We are experiencing cracking of 1206 .1uf/50V capacitors on our boards. Design is keeping the caps away from the board edge 0.200 and perpendicular to the longest edge but still they crack even in the interior of the board. Recommendations? bds are
Electronics Forum | Thu Mar 04 10:21:55 EST 1999 | Igmar
Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just a rec
Electronics Forum | Tue Aug 17 10:37:45 EDT 2004 | M.Enright
Some cracks are really obvious,straight down the middle of the capacitor.Some are slight hair line fractures which fail at ICT.In all cases seen,all cracks are through the centre of the cap.My worry is that there may be some which have fractures and
Electronics Forum | Wed Jun 12 08:01:04 EDT 2013 | mun4o
hi, i have problem with ceramic capacitor 10uF ±10% 16V X7R 1206.Problem is as follows:ICT ( Teradyne 8851 ) measured value 6 ?? 8uF ( about 70% of all lot).I decide that components ( samsung ) are defective.I buy one "type&reel" capacitors "Murata"
.gif)
winsouce.jpg)