Electronics Forum | Fri Apr 08 09:42:31 EDT 2022 | bukas
thanks for help guys. I changed HDD and mounted image from a working machine then I ran a calibration. It still moves paste left and right but distance is much smaller so prints are acceptable. I have a spare vision card will try it tomorrow. Do I ne
Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "
Electronics Forum | Thu Feb 09 19:35:09 EST 2023 | youngbuck
Hello, We have a Dek Infinity when powering up will not initialize due to an error that says Rising Table Error (Position Error). I try to go to Diagnostics but it will not let me into anything. I press start when I'm in diagnostics and it just error
Electronics Forum | Fri Feb 09 01:46:55 EST 2024 | erikfriesen
I have a 2005 DEK Horizon 02i, the cmos batt was dead, so I replaced, and reset the bios. The device hangs in initialization, eventually erroring out. The vision led's blink rapidly during this period. Also, the card shows an error in device manag
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Wed May 19 14:44:53 EDT 2004 | JSK
Low voltage readings on (PSU 2). should be: = is: +12V = 4.3V -12V = 8.6V +24V = 7.6V Anysuggestions? (Other than buying a new card.) Thanks, jsk
Electronics Forum | Sat Oct 21 18:47:40 EDT 2006 | Mats
Hi, When you turn on the machine; check the display's on the cards in the lower right. What is the numbers after the machine is fully up? We will go from there. /
Electronics Forum | Sat Oct 21 19:41:44 EDT 2006 | Ola
It could sometimes even be easier to acess it from the lower right front; pull the card chassi gently out onto a firm & leveled ground, so that the cables in the rear end of the chassi Not get "pulled to much". You still need to "crawl in".
Electronics Forum | Thu Jul 23 12:59:29 EDT 2009 | msherwood
Yes it was working. We moved it to another build and it stop. Which card are we talking about. X9, SBC40.
Electronics Forum | Wed May 05 04:25:42 EDT 2010 | vms
We sale the cognex cards for 3500.00 all of the time, think we need to raise our prices. Right bruce? Harry
.png)
