Electronics Forum | Wed Apr 06 07:59:17 EDT 2005 | cyber_wolf
Did you check the ribbon cables on either side of the X axis for cracks ?
Electronics Forum | Tue Apr 05 05:19:30 EDT 2005 | blueflag
Breakdown help machine will not 0 set upper end point limits on Z axis Theta / lower end point missed Thanks Colin
Electronics Forum | Tue Apr 05 12:45:01 EDT 2005 | cyber_wolf
Make sure your matrix tray is up high enough. The components in the matrix tray should be at least at board level. Also check your component height in the package list. If all that is OK then, check those Z locks I spoke of earlier.
Electronics Forum | Thu Apr 07 08:57:06 EDT 2005 | blueflag
have been through somethings with an engineer on the help desk and the concusion is that it is the z motor with the encoder that is causing the fuse to go so have ordered another. Not cheap though at nearly �500. Thanks very much for your help, it
Electronics Forum | Wed Apr 06 09:16:31 EDT 2005 | blueflag
Ive just checked all the cables that i can see and there seems to be nothing wrong. Have just put a brand new fuse in to mot z card and it has blown it. machine boots up, initiate the hardware and everything goes ok until it does the z height then i
Electronics Forum | Thu Apr 07 07:17:54 EDT 2005 | cyber_wolf
Colin, At this point you may consider calling in Mydata. I told you the basic things I have seen cause your problems. It sounds as if you may have a bad card, and or short somewhere. Possibilities: XWB Small booster on the front of the computer bo
Electronics Forum | Mon Jul 06 02:23:31 EDT 2009 | bobpan
Hello Andras, I worked on those machines 10-15yrs ago. I dont recall having software or having to re-install it. Can you state the problem that you are having with the machine. I can try to help but most of my technical information has long been gone
Electronics Forum | Tue Apr 05 12:01:17 EDT 2005 | blueflag
Thanks for reply we have found a blown fuse on the back plane for the mot-z pcb . But we now have problems with Z height, i am trying to auto-teach devices from the tray wagon (qfp etc) and it is not always lowering the nozzle to the component. i ha
Electronics Forum | Sat Jul 04 01:11:17 EDT 2009 | cesar444
Dear Adresse, I ’m sorry my disturbing you with my e-mail, but I need some help from you. I have a QUAD 1000 SMT machine, and I would be need a software-driver copy and a technical drawing to this machine. If you could help me, pls send these by e-m
Electronics Forum | Tue Apr 05 11:03:13 EDT 2005 | cyber_wolf
There are several things that can cause these errors. It sounds as if you have 2 problems. A (Z) problem and a theta problem. 1. Check that the Z-locks are functioning properly in the service program. Make sure that when they are un-locked they don'
