Electronics Forum | Tue May 09 21:56:22 EDT 2006 | KEN
Yes. Teach 24mm feeder. 1. Set pickup to "Teaching" or "relative". 2. Adjust coordinate. 3. Celebrate with high fives and chest bumps like in the beer comercials.
Electronics Forum | Wed Nov 12 16:04:11 EST 2008 | charliedci
I have about 8 pair of the 590 in use in thru hole production. Had to replace 1 set of blades because of overpressure (50psimax) and a valve over past year. They work well for light to medium work. The replacement blades were around $20.00.
Electronics Forum | Mon Apr 26 03:00:43 EDT 2010 | fujiphil
Check the following... 1. Set the fiducial reading to SCAN... 2. Clean the half mirror of the fiducial camera... 3. Check the CCD Camera...maybe blown fuse inside. Hope this will help.... Good luck....
Electronics Forum | Wed Jun 19 16:18:11 EDT 2024 | proceng1
One thing that I did to eliminate 1 set of variables is I calculated the slowest belt speed that puts the board in reflow for the longest time spec'd for by the paste manufacturer. So every recipe runs at that belt speed. Eliminating the juggling o
Electronics Forum | Thu Jun 23 15:31:46 EDT 2005 | james
The ideas so far are good, but yet remember, we are running 4 different lines with "1" set of parts that are never removed from the feeders. We can not get purchasing to buy extra reels of the of the most used parts, and these parts travel from line
Electronics Forum | Tue Apr 12 21:43:50 EDT 2016 | cmarasigan
There is an auto teach of QFP component for CM402 wherein machine can auto recognize number of pins, pin pitch. Just make sure on your part data you have selected the right reference part (Ref: 171)for QFP. For manual component recog; 1. Set Comp si
Electronics Forum | Thu Sep 19 02:29:55 EDT 2019 | robl
Hi all, Is anyone else running RC5.16 with an electrical tester? After the last system update all 3 of our iineo's have picked up a bug: When we change an element the software forces all applicable parts in that trolley to go through electrical te
Electronics Forum | Tue May 05 16:58:08 EDT 2009 | billmeye
I don't have CircuitCam, I'm using Unicam with Mydata. In Unicam I have a Theta Offset setting for each package witch determines the default rotational angle with respect to the pin 1 setting within the package data. With Mydata, the package inform
Electronics Forum | Tue Apr 09 08:56:18 EDT 2013 | leemeyer
I made a new program today that will run on 2 machines and my AP did not create the 2 additional boards that you are speaking of. I'm not sure what thats all about. This is my method: 1. Set up a Assembler/system in AP that includes both machines tha
.gif)
winsouce.jpg)
