Electronics Forum | Wed Nov 27 13:07:07 EST 2013 | processman
Hi, Can somebody confirm the correct operation of the rear clamp rails on an Ersa Ecoselect 2.... Do they only activate when the PCB comes into the machine then release, or stay activated thru out the flusing, heating, soldering etc
Electronics Forum | Tue Dec 03 14:05:09 EST 2013 | chadsuckow
You can have it either way. In each program you can select to have the side pressure active for the entire program. The factory setting is to have it release immediately after it pushes the pcb against the fixed rail.
Electronics Forum | Thu Dec 12 12:44:45 EST 2013 | jaimebc
Just to add to Chad's response, there is box that you need to check in the program editor, ours is under the colum soldering unit one, click on the icon at the bottom, you should now be able to see a box " fix horizontal permanently". Check this box
| 1 |
.gif)
winsouce.jpg)
