Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Sun Jun 25 00:33:13 EDT 2000 | Robertsam
I had problembs with taping the signal to on the buzzer with machine tower light.However I try to connect parrallel to the light but the control board which connected to the light malfunction after 1/2 hour.The tower light is trigger by the ground s
Electronics Forum | Wed Aug 03 12:18:49 EDT 2016 | dekhead
You don't say what kind of printers you are running, but if you had multiple light sources and independent control of direct an oblique lighting (either manual and software controlled) usually pretty "do-able". I have customer doing almost exclusivel
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Fri Apr 08 05:22:47 EDT 2005 | Bored
The light events are: Red - Alarm - Indicates that an alarm exists.This also occurs when the emergency power stop button has been used to stop the belt and turn off heater power. Orange - Alert - Indicates that an alert condition exists. Green - R
Electronics Forum | Tue May 10 17:50:08 EDT 2005 | davef
Consider: * Changing your temporary solder resist [TSR] to a light cure. * Contracting with your board fabricator to apply the TSR. * Gaining better thickness control of your application process by silk screening the current TSR. * Forcing more air c
Electronics Forum | Wed May 14 18:22:07 EDT 2014 | hegemon
Dave is touching on one of those magical things that keeps us process engineers well paid and dancing (Well, some of us, lol). Heavy boards with light components. Solder Follows heat. Component heat up earlier. Repeat, Solder follows the heat. Care
Electronics Forum | Wed May 15 05:44:04 EDT 2019 | peterchan
1、YSVJ-650B three-group multi- blades cutting machine, multiple sets of tools run at the same time, split the whole piece at one time, greatly improve production efficiency; multiple sets of tool design ensure that the split plate effect is not defor
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Sat Feb 20 09:41:51 EST 1999 | Andy
| We are using .040" diameter fiducials (global and local) on our boards. They are solder covered and HASL. I get batches of boards where the p&p vision system has trouble reading the fiducial. The fiducial looks dark on the screen. The board ven
